Quick Start Guide

3.3 Loading Recording Paper (With a Printer Module Installed)
44
Retainer
Axle
2
1
Loading Recording Paper in the Model 8995-01 A6 Printer Unit
Print Roller
Back Side of
Recording Paper
Stock Cover
1 Push the stock cover to open the stock cover.
2 Raise the head-raising lever.
The print head is separated from the print roller.
(Head-raised condition)
3 Insert the paper through the slot under the print
roller, and pull the paper out so that the print
roller turns.
4 Insert the paper roll axle through the center of
the paper roll, and place it in the retainers.
5 Align the edge of the paper that you pulled out
with the edge of the paper still on the roll.
If the paper is misaligned, it will crease as it feeds.
6 Return the head-raising lever to the lowered
position.
The print head should rest on the paper. (Head-low-
ered condition)
7 Insert the paper through the paper outlet in the
stock cover, and pull a little out.
8 Close the stock cover and cut the paper using
the cutter at the paper outlet to finish the proce-
dure.
Print Roller
Paper Cutter
Head-Raising Lever
Head-Raising
Lever
Printer
Head