Quick Start Guide

4.3 Recording Simple Waveforms
53
To Change Settings
See "4.4 Setting Measurement Configuration on the Wave-
form Screen"
"5.7 Setting Input Channels from the Waveform Screen"
"6.12 Making Trigger Settings on the Waveform Screen"
in the Instruction Manual
Setting Items
Input Channel
Settings Dialog
After changing a setting, press the START key again.
However, if the change is made while measuring, the setting is reflected at the moment it
is
changed.
Changing the timebase or recording length
Use the CURSOR keys to move the cursor to the set-
ting item, and press F1 to F8 to select the setting val-
ue. Pressing the SUB MENU keys changes available
setting items.
Changing the selected input channel
Press the UNIT or CH key to display the [CH SET] di-
alog, and select the channel to be changed.
• Changing the measurement range
Turn the inner RANGE knob.
• Changing the waveform display position (zero
position)
Turn the outer POSN knob.
• Erasing unwanted waveforms
Select the unit (module) and channel of the
waveform to be erased, and change [On] to [Off].
Press the ESC key to remove the dialog.
Verifying a Waveform
A waveform’s horizontal axis can be
expanded or compressed (⇒ p. 62)
The horizontal axis can be expanded or compressed
by setting the magnification in the [Mag] (Magnifica-
tion) field.
By selecting the [Zoom] button, a section of the wave-
form can be expanded.
See "8.9 Magnifying and Compressing Waveforms" in the
Instruction Manual
Reading values at cursors (⇒ p. 63)
Press the TYPE key to open the [A/B Cursor] dialog.
Select the cursor type, and move the A or B cursor by turning the
A or B knob, respectively.
The values at the A/B cursors appear at the top right.
See "8.8 Cursor Values" in the Instruction Manual
Shuttle
Scrolling a waveform
(⇒ p. 35)
Turn the inner Jog knob of the
SCROLL control to scroll slowly,
or the outer Shuttle knob to scroll
quickly.
See "8.1 Scrolling Waveforms" in the
Instruction Manual
Measurement
value at cursor
Cursor A
Cursor B
Jog