Quick Start Guide

5.4 Saving Procedures and Contents
70
5.4 Saving Procedures and Contents
Basically, three methods are available for saving.
To save automatically while
measuring
To save immediately upon
pressing the SAVE key
To save selected contents
Auto Save
This method is convenient for saving
specific types of data, such as wave-
forms or images, or when you want
to save while monitoring. Specify
what you want to save before press-
ing the SAVE key.
(Default setting)
Press the SAVE key to select and
save the selected contents. No set-
tings need to be made on the Save
Settings screen, as settings can be
made on any screen.
Quick Save Selection Save
Automatically saves all acquired
measurement data for the specified
recording length. Various types of
data can be saved at the same time.
Select the save destination and con-
tents before measuring (
⇒ p. 59).
After installation and connection,
turn power on.
Insert storage media
Set measurement configuration,
etc.
Set the Auto Save setting [On]
Specify the saving destination
Select what to save
Measure
Saving proceeds automatically
From the Save Settings screen,
open the [Auto Save] page
The following can be saved
simultaneously:
• Waveform Data
• Numerical Calculation Result
s
• Screen Image
After installation and connection,
turn power on.
Insert storage media
Set the function of the SAVE key to
[Quick Save]
Specify the saving destination
Select what to save
Press the SAVE key*
1
Save
From the Save Settings screen,
open the [SAVE key] page
Any of the following can be
saved:
• Waveform Data
• Settings Data
• Numerical Calculation Results
• Screen Image
After installation and connection,
turn power on.
Insert storage media
Set the function of the SAVE key to
[Selection Save]
Press the SAVE key.
Specify the saving destination
Select what to save
Select the [Execute] button*
1
Save
From the Save Settings screen,
open the [SAVE key] page
Any of the following can be
saved:
• Waveform Data
• Settings Data
• Numerical Calculation Results
• Screen Image
Verify before saving
• Is storage media inserted?
• Is write-protection on the storage media disabled?
• Is the specified save destination correct?
• Is Auto Save set to [On] for automatic saving?
*1.To save only a section of a waveform, demarcate
the section with the A/B cursors. (Saving a wave
-
form section is not available with Auto Save)
To save a screen image, display the desired
screen before saving.