Quick Start Guide

6.1 Printing Methods and Contents
76
6.1 Printing Methods and Contents
To print automatically while
measuring
To print immediately upon
pressing the PRINT key
To select and print specified
items after measuring
Auto Print
Specify what you want to print be-
fore pressing the PRINT key. It may
be convenient to print certain data
optionally and to print simultaneous-
ly while analyzing.
(Default setting)
After pressing the PRINT key, select
items to print before printing. This
method is convenient for printing dif-
ferent items each time.
Quick Print
Selection Print
With the Memory Function*, prints au-
tomatically after acquiring measure-
ment data for the specified recording
length.
With the Recorder Function (support-
ed only by the internal printer), prints
in real time while recording.
With the FFT Function, prints auto-
matically after FFT calculation.
In either case, before measuring, se-
lect the desired items to print.
* When the Roll Mode is enabled, waveforms can be printed while being dis
-
played. (However, printing is delayed if the timebase is set faster than 50
0
ms/div.)
Basically, three printing methods are available.
Install recording paper (⇒ p. 42)
After installation and connection,
turn power on.
Set measurement configuration,
etc.
Set the Auto Print setting [On]
Select the print destination
Select items to print
Measure
Print
The following can be printed
simultaneously.
• Waveform Data
• Numerical Calculation Results
Install recording paper (⇒ p. 42)
After installation and connection,
turn power on.
Select [Quick Print] as the PRINT
key action
Select the print destination
Select items to print
Press the PRINT key
Print
Any of the following can be print-
ed:
•Whole Waveform
• A-B Waveform
• Waveform before and after
trigger event
• Report
• List (Settings List)
• Calculation results
• Screen Image
• (Screen Link)
Install recording paper (⇒ p. 42)
After installation and connection,
turn power on.
Select [Selection Print] as the
PRINT key action
Select the print destination
Press the PRINT key
Select items to print
Print
Any of the following can be
printed:
• Whole Waveform
• A-B Waveform
• Waveform before and after
trigger event
• Report
• List (Settings List)
• Calculation results
• Screen Image
Verify before printing
• Is the recording paper loaded
correctly?
• Is the printing destination set
correctly?
• For automatic printing: Is Auto
Print enabled [On]?
If both Auto Print and Auto Save are enabled, saving is performed first.
However, if the Roll Mode is used with the Memory function (default setting
:
Auto), printing is performed first.