User Manual

4.3 Acquiring Waveforms Using the Utility Functions
101
4
Chapter 4 Measurement Configuration Settings
This applies to the Memory function only.
Displayed waveforms are retained on-screen and overlaid with new waveforms.
Use this to compare new waveforms with those recorded immediately before.
(When the trigger mode is [Repeat] or [Auto])
Methods are available to automatically overlay waveforms while measuring, and
to overlay waveforms manually without limit.
4.3.2 Overlaying Waveforms
Normal Display
Waveforms with the Overlay Function
2
1
Overlay
To open the screen: Press the SET key → Select with the SUB MENU keys →Status Settings screen
See Screen Layout (
⇒ p. 27)
Operating Key Procedure
1
Enable/disable the Overlay function.
CURSOR
Move the cursor to the [Overlay] item.
F1 to F8
Select either choice.
2
When [On] is selected: Choose the overlay method.
CURSOR
Move the cursor to the [Method] item.
F1 to F8
Select either choice.
Off Overlay disabled (default setting).
On Overlay enabled.
Auto Normal overlay enabled.
When the trigger mode is [Repeat] or [Au
-
to], waveforms are overlaid from starting
until measurement stops.
Manual Waveforms are manually overlaid on the
screen. Waveforms remain on-screen re
-
gardless of the trigger mode.
Measurement (Waveform Acquisition)
When [Manual] is selected: to overlay manually (⇒ p. 102)
This mode cannot be used simultaneously
with the Roll Mode.
"When the Overlay function is enabled
([On])." (
⇒ p. 102)