User Manual

109
5
Chapter 5 Input Channel Settings
Input Channel
Settings Chapter 5
About screen contents:
"2.5.2 Channel Settings Screen" (
⇒ p. 30)
1
Open the Settings screen
2
Menu selection
Set the measurement range, scaling and input waveforms for input channels on the Channel Settings
screen. Input channel settings can also be made on the Waveform screen. (⇒ p. 128)
3
The setting choices for input channels depends on the type of input module. Refer to the Input Module Guide for
details. If the measurement range is unknown, it can be set automatically.
See "3.3.5 Automatic Range Setting (Auto-Ranging Function)" (
⇒ p. 73)
Page selection
Input Channel Settings on the Channel Settings Screen
Input Module (Analog Channel) Settings
(⇒ p. 110)
[One Ch] Page
• Selection of channel(s) to set
• Measurement range setting
• Measurement mode, input coupling, low-pass
filter and probe attenuation*
1
settings
• Channel comment*
2
settings (⇒ p. 112)
*1. Setting choices depend on the type of input module.
These settings are also available on the [All Ch]
page. (
⇒ p. 124)
*2. This setting is also available on the [Comment] page.
(
⇒ p. 123)
Logic Channel Settings
[Logic] Page
• Waveform color settings (
⇒ p. 177)
[Comment] Page
• Channel comment settings (⇒ p. 123)
Scaling Settings (⇒ p. 117)
[One Ch] Page
When using a clamp or external sensor, set to
convert measurement units for display.
These settings are also available on the [Scaling] page.
(
⇒ p. 125)
Input Waveform Settings
[One Ch] Page
• Enable/disable waveform display, set display
color (
⇒ p. 165)
• Zero position setting (⇒ p. 166)
• Vertical magnification and arbitrary display
range (Variable function) settings*(
⇒ p. 208)
* These settings are also available on the [Variable]
page.
(⇒ p. 126)
Other Settings
• Monitoring the input level (⇒ p. 116)
• Making copy settings (
⇒ p. 127)
• Adding titles*(⇒ p. 112)
* Titles can be included on printouts.