User Manual

5.4 Converting Input Values (Scaling Function)
119
5
Chapter 5 Input Channel Settings
The full span of output from a sensor can be displayed. (⇒ p. 210)
To verify correct scaling settings: Scaling Check
When appropriate numerical values have been entered,
the converted physical value is displayed.
Verify that it is converted correctly.
1
Select the [Check] button.
2
Select the [Close] but
-
ton to close the dialog
.
3
The [Scaling Check] dialog appears
.
To reset Scaling settings
Select the [Reset] button.
Scaling settings are reset.
Using the Scaling and Variable functions (⇒ p. 208) in combination
At factory shipping, automatic correction of the variable function (⇒ p. 341) is set
to
[On].
At this time, the Variable setting is altered so that it is linked to (dependent upon)
the measurement range and Scaling settings. If you want the Variable function
setting to take priority, use either of the following procedures:
• Set Scaling first, and then set the Variable function
• Set a Variable value before Scaling, and then set Scaling.
When automatic correction of the Variable function (Variable Auto Adjustment) is
disabled (Off), the Scaling and Variable settings are unlinked (independent of
one another).