User Manual

5.7 Setting Input Channels from the Waveform Screen
128
Input channel and Waveform display settings can be made from a channel's set-
ting dialog.
Setting choices are the same as on the [One Ch] page of the Channel Settings
screen.
About analog channel settings:
See "5.1 Analog Channel Settings" (⇒ p. 110)
About setting choices for each input module:
See "Chapter 3 Input Channel Settings" in the Input Module Guide
Two setting methods are available from the Waveform screen, as follows:
• Set individual channels
• Set from the All Channels List (Channel Settings)
Move the cursor to an item to be set within the dialog, and select with the F keys.
Measurement range and zero position can be set by turning the RANGE/POSN
knobs, regardless of cursor location. (⇒ p. 111)
Press the RANGE/POSN knobs. The [CH SET] dialog appears.
Display appearance depends on the particular input module.
Press the FUNCTION MODE key, then press the F5 [Channel Set] key.
The [CH ALL SET] dialog appears. Current input channel settings can be verified
in the list.
5.7 Setting Input Channels from the Waveform
Screen
Setting Individual Channels ([CH SET] dialog)
Setting from the All Channels List (Channel Settings)
([CH ALL SET] dialog)
Channel No.
Vertical Axis Magnification
Input Coupling
Display Color
Measurement Mode
Low-Pass Filter
Vernier Function
Fine adjustment for input values. This setting is onl
y
available in this dialog.
"8.10 Fine Adjustment of Input Values (Vernier Func
-
tion)" (⇒ p. 211)
Zero Adjust
or Auto-balance
(8939 or 8960)
Module Unit No.
Waveform Display
Measurement Range
Zero Position
The displayed
settings can be
switched
Low-Pass Filter
Input Coupling
Zero Position
Vertical Axis Magnification
Unit (Module) and
Channel No.
Display Color
Measurement Range