User Manual

129
6
Chapter 6 Trigger Settings
Trigger Settings Chapter 6
Open the Settings screen
Menu selection
Page selection
1
2
Make trigger settings on the Trigger Settings screen. You can also make them on the Waveform screen
(⇒ p. 161). Setting choices are function-dependent.
About screen contents:
"2.5.3 Trigger Settings Screen" (
⇒ p. 33)
3
Trigger Settings
• Trigger mode setting (⇒ p. 132)
• Combining logic (AND/OR) for multiple trigger
sources (
⇒ p. 133)
• Pre-trigger settings (Memory function and FFT
function only)
(
⇒ p. 134)
• Trigger timing settings (⇒ p. 138)
• Trigger source settings
Timer Trigger Settings (⇒ p. 156)
• Setting recording start and stop times
• Setting a recording interval
Analog Trigger Settings*
1
(⇒ p. 140)
[Analog] page
• Level trigger(⇒ p. 144)
• Window trigger (In-Window trigger, Out-of-Window
trigger) (
⇒ p. 146)
• Period trigger (In-Period, Out-of-Period)(⇒ p. 147)
• Glitch trigger*
2
(⇒ p. 149)
• Slope trigger*
2
(⇒ p. 150)
• Voltage sag trigger*
2
(⇒ p. 152)
• Trigger filter*
3
• Event count*
4
*1. Setting choices depend on the type of analog triggering.
*2. Memory function and FFT function only
*3. Can be set for each analog trigger selection
(except for Slope and Glitch triggers).
*4. [Expanded] setting only
Logic Trigger Settings (⇒ p. 153)
[Logic] page
• Setting combining logic for logic triggers
• Trigger filter settings
• Trigger pattern settings
Manual Trigger Settings (⇒ p. 159)
External Trigger Settings (⇒ p. 160)
• External control terminal connections and
settings (
⇒ p. 387)
Trigger Source
Trigger Output (⇒ p. 392)
Trigger Settings Available on the Trigger Settings Screen
Trigger Search (⇒ p. 216)