User Manual

7.1 Making Input Waveform Display Settings (Analog Waveforms)
166
Set the waveform zero position (in this example, zero volts) for display on the
vertical axis.
The waveform display range can be verified on the Level Monitor.
The following two setting methods are available:
• Using the operating keys
• Using the RANGE/POSN knobs (settable regardless of cursor position)
7.1.2 Setting the Waveform Display Position
(Zero Position)
Normal Waveform
Changed Zero Position
100%
0V
0%
50%
W
aveform
D
isplay Range
Zero Position: 50%
0V
Zero Position: 25%
25%
Setting the Zero Position
To open the screen: Press the SET key → Select with the SUB MENU keys →Channel Settings scree
n
See To set from the Waveform screen (⇒ p. 128), To set in the Channel List (⇒ p. 124)
Using the Operating Keys
Operating Key Procedure
1
SHEET/PAGE
Select the [One Ch] page.
2
CURSOR
Move the cursor to the [Position] item.
3
F1 to F8
Set the zero position.
The valid setting range depends on display mag-
nification.
With x 1 magnification: –100 to 150%
See "Entering Numbers" (
⇒ p. 64)
Using the RANGE/POSN Knobs
Turn the outer POSN knob.
Higher Position
Lower Position