User Manual

7.4 Composite Waveforms (X-Y Waveforms)
180
This applies to the Memory function only.
Any channels can be displayed as a composite during or after measurement. To
make a composite while measuring, measurement configuration settings and X-
Y composite have to be set before starting measurement. Refer to the appropri-
ate chapters for measurement configuration settings. This section describes the
composite waveform settings.
7.4 Composite Waveforms (X-Y Waveforms)
1
2
3
4
X-Y Waveforms
To open the screen: Press the SET key → Select with the SUB MENU keys →Sheet Settings screen
See Screen Layout (
⇒ p. 168)
Composite setting is available both before and after measurement.
Operating Key Procedure
1
Set the Display Type.
CURSOR
Move the cursor to the [Display Type] item.
F1 to F8
Select either choice.
2
Set Split-Screen display (⇒ p. 172).
CURSOR
Move the cursor to the [Split-Screen] item.
F1 to F8
Select the number of Graphs. (Available choices
depend on the Display Type setting.)
3
Set the Composite Area.
CURSOR
Move the cursor to the [Area] X-Y Composite
item.
F1 to F8
Select either choice.
4
Set line interpolation (as occasion demands).
CURSOR
Move the cursor to the [Dot-Line] item.
F1 to F8
Select either choice.
X-Y Comp Displays X-Y waveforms.
Wave & X-Y Displays both X-Y composite and
analog waveforms.
Whole Use the whole range for the composit
e
waveform. (default setting) (default setting
)
A-B Use the range specified by the cursors.
Procedure to specify a range with A/B cur
-
sors:(⇒ p. 193)
Dots Do not interpolate straight lines. Input sig
-
nals (sampling data) are displayed and re
-
corded as is.
Line Interpolate straight lines. This can improve
display visibility, although the display
speed is slower than Dots display.
(default setting)
"Making Partial Composites" (⇒ p. 182)
To make a partial composite while mea-
suring, first acquire waveforms and
specify the waveform range with A/B
cursors.