User Manual

8.8 Cursor Values
199
8
Chapter 8 Waveform Screen Monitoring and Analysis
Displays the voltage values at the A and B cursors for the selected channel(s), or
the voltage between A/B cursors.
About cursor values:
See "8.8.1 About Cursor Types and Values" (
⇒ p. 195)
8.8.3 Reading Voltage Values (Horizontal Cursors)
Horizontal Cursor Settings
To open the screen: Press the DISP key → Waveform screen
Operating Key Procedure
1
Select the Cursor Type.
CURSOR
F3
Move the cursor to the [Type] item.
Select
[Horizontal ].
(The selection can also be made by pressing the
TYPE key)
2
Select the number of cursors to enable.
CURSOR
F1 to F8
Move the cursor to the [Num] item.
Select either choice.
3
(When 2 cursors are enabled)
Select the cursor motion method.
CURSOR
F1 to F8
Move the cursor to the [Motion] item.
Select either choice.
4
Select the cursor speed.
CURSOR
F1 to F8
Move the cursor to the [Speed] item.
Select either choice.
(The selection can also be made by pressing the
SPEED key)
5
Select the channels for which to display cursor values.
CURSOR
F1 to F8
Move the cursor to the [Cur A] or [Cur B] item.
Select either choice.
6
Move the A/B cursors and read the cursor values.
A/B knobs
Turn (inner) Knob A and (outer) Knob B to move
the A/B cursors.
1 Enable only cursor A. (skip to Step 4)
2 Enable both A/B cursors. (continue to Step 3)
Independent The A/B cursors move independently.
Together The A/B cursors move together.
Fast, Medium or Slow
All, or channel numbers for which to display cur-
sor values
Display the dialog
Press the TYPE key.
The [A/B Cursor] dialog appears.
(It also appears by pressing Knob A)
The TYPE and SPEED keys can be used regardless of cursor position
.
Knob A
Knob B
Cursor Type
1
2
3
4
55
"About Cursor Values" (⇒ p. 196)
Measurement Values
Cur A Cur B
Speed of cursor motion
Set this only when the number o
f
cursors (Num) is set to [2].