User Manual

8.8 Cursor Values
200
Displays the data values at the intersections (trace points) of cursors and wave-
forms.
About cursor values:
See "8.8.1 About Cursor Types and Values" (⇒ p. 195)
8.8.4 Reading Time and Voltage Values (Trace Cursor)
Trace Cursor Setting
To open the screen: Press the DISP key → Waveform screen
Operating Key Procedure
1
Select the Cursor Type.
CURSOR
F4
Move the cursor to the [Type] item.
Select [Trace].
(The selection can also be made by pressing the
TYPE key)
2
Select the number of cursors to enable.
CURSOR
F1 to F8
Move the cursor to the [Num] item.
Select either choice.
3
(When 2 cursors are enabled)
Select the cursor motion method.
CURSOR
F1 to F8
Move the cursor to the [Motion] item.
Select either choice.
4
Select the cursor speed.
CURSOR
F1 to F8
Move the cursor to the [Speed] item.
Select either choice.
(The selection can also be made by pressing the
SPEED key)
5
Select the cursor (horizontal) length.
CURSOR
F1 to F8
Move the cursor to the [Line] item.
Select either choice.
1 Enable only cursor A. (skip to Step 4)
2 Enable both A/B cursors. (continue to Step 3)
Independent The A/B cursors move independently
.
Together The A/B cursors move together.
Fast, Medium or Slow
Short or Long
Display the dialog
Press the TYPE key.
The [A/B Cursor] dialog appears.
(It also appears by pressing Knob A)
The TYPE and SPEED keys can be used regardless of cursor position
.
1
2
3
4
6
7
5
Knob A
Knob B
Cursor Type
Speed of cursor motion
Set this only when the num-
ber of cursors (Num) is set
to [2].
To perform partial composition or calcula
-
tion, specify the desired range.
• XY composition ("Making Partial Com
-
posites" (⇒ p. 182))
• Numerical value calculations
(
⇒ p. 193)
• Waveform calculations (
⇒
p. 193)
Calculation settings: Analysis Supplemen
t