User Manual

8.8 Cursor Values
201
8
Chapter 8 Waveform Screen Monitoring and Analysis
Operating Key Procedure
6
Select the axis to serve as the origin of cursor move-
ment.
(Only when using the Timebase 2 with the Memory function)
CURSOR
F1 to F8
Move the cursor to the [Axis] item.
Select either choice.
7
Select the channels for which to display cursor values.
CURSOR
F1 to F8
Move the cursor to the [Cur A] or [Cur B] item.
Select channel(s) for display.
8
Move the A/B cursors and read the cursor values.
A/B knobs
Turn (inner) Knob A and (outer) Knob B to move
the A/B cursors.
Timebase 1 or Timebase 2
All, or channel numbers for which to display cur-
sor values
"About Cursor Values" (⇒ p. 196)
Time Values
Measurement
Values
If cursors are not visible on-screen even when enabled by the A/B Cursor
settings
Cursor measurements are available even when the A or B cursor of off-screen.
Turn Knob A or B as needed to move each cursor on-screen.
To view the waveform before or after the A/B cursors when off the screen
When using the A/B cursors, the waveform at an off-screen cursor location can
be displayed using the Jump function.
See "8.3 Specifying a Display Location (Jump Function)" (⇒ p. 188)
When specifying channels on which you choose to display cursor values
(Cur A and Cur B)
Even when cursors A and B are each assigned to different channels, the potential
difference between A and B can be obtained.