User Manual

8.9 Magnifying and Compressing Waveforms
209
8
Chapter 8 Waveform Screen Monitoring and Analysis
Variable Function (Per-Division Setting)
To open the screen: Press the SET key → Select with the SUB MENU keys →Channel Settings scree
n
See To set from the Variable List (⇒ p. 126)
Operating Key Procedure
1
Enable the Variable function.
CURSOR
F2
Move the cursor to the [Variable] item.
Select
[On].
2
Enable the 1div (per- division) setting.
CURSOR
F2
Move the cursor to the [1div] item
(if the [Upper-Lower] is currently selected).
Select
[1div].
3
Set the range of values to display per division.
CURSOR
F1 to F8
Move the cursor to the [Range/div] item.
Enter a numerical value. (Measurement units de-
pend on the measurement mode of the input
module.)
See "Entering Numbers" (
⇒ p. 64)
4
Set the waveform zero position to display on the vertical
axis.
CURSOR
F1 to F8
Move the cursor to the [Position (%)] item.
Enter a numerical [%] value.
See "Entering Numbers" (
⇒ p. 64)
When Scaling is enabled, values are dis
-
played in scaling units.
When these settings are changed, the nu
-
merical values indicating the display range
on the level monitor are changed accord
-
ingly.
2
1
4
3
Variable Function (Upper/Lower Limits Setting)
To open the screen: Press the SET key → Select with the SUB MENU keys →Channel Settings scree
n
See To set from the Variable List (⇒ p. 126)
Operating Key Procedure
1
Enable the Variable function.
CURSOR
F2
Move the cursor to the [Variable] item.
Select [On].
2
Enable the Upper-Lower (Upper/Lower limits) Setting.
CURSOR
F2
Move the cursor to the [Upper-Lower] item (if the
[1div] is currently selected).
Select
[Upper-Lower].
3
Set the upper and lower limits.
CURSOR
F1 to F8
Move the cursor to the [Upper] item.
Enter the numerical value.
See "Entering Numbers" (
⇒ p. 64)
CURSOR
F1 to F8
Move the cursor to the [Lower] item.
Set in the same way.
213