User Manual

10.1 Storage Media
248
An optional 9718 HD Unit (optional built-in unit installed prior to shipment) is
required to save or load data to/from a hard disk.
The capacity of the hard disk is 60 GB. (1 GB = 1,000,000,000 bytes)
The hard disk is initialized prior to shipment.
Data can be read and written to a USB memory device connected to the USB
port.
USB Memory Device Insertion & Removal
When a USB memory device is inserted, the name of the storage media appears
on the File screen.
See "Storage Media Names" (⇒ p. 254)
10.1.4 Using a Hard Disk
• Do not turn the power off during hard disk operation (saving or loading).
The data being saved or loaded may be damaged.
• Do not subject the hard disk to extreme shock or vibration. Doing so may dam-
age the hard disk.
• Use the hard disk in an environment with a temperature of 5°C or above.
• Do not operate the instrument at a slanted angle. It may not work properly.
10.1.5 Using USB Memory Devices
• After confirming proper connector orientation, connect it to the USB port.
Attempting to force a connector with the wrong orientation may cause damage.
• Do not remove the USB memory device while it is in use. Data may become
corrupted.
• Do not transport the instrument while a USB memory device is connected.
Damage could result.
• Not all commonly available USB memory devices are supported.
Right Side of Instrument
Inserting a USB memory device
Confirm that the connector of the USB mem
-
ory device is aligned with the USB port, an
d
insert it all the way in.
Removing a USB memory device
Confirm that the instrument is not accessin
g
(reading or writing) the USB memory device
,
then remove it.
(No particular instrument operation is re
-
quired to remove a USB memory device.)
USB Port