User Manual

ManualsBrandsHIOKI ManualsTest & Measuring EquipmentMemory Recorder HIOKI HiCORDER 8860-50

2.4 Waveform Screen

Chapter 2 Operating Keys and Screen Contents

Setting Items and Choices

Current setting choices are displayed.

To change a setting:

Use the CURSOR keys to move the cursor to the setting item, and select your choice by the corresponding F key.

See "3.3.2 To Change a Setting" (

⇒ p. 62)

To switch displayed setting items:

Press the SUB MENU keys to switch which setting items are displayed. (Some items are function-dependent)

• Memory Function and Recorder Function

[Config]

↔ [Trigger] ↔ [Num Calc]* ↔ [Mem Div]*

* Only with Memory Function

• Real-Time Saving Function

[Config]

• FFT Function

[FFT(1/2)]

↔[FFT(2/2)] ↔ [Trigger]

Measurement Configuration & Trigger Criteria Settings [Config]

Timebase

Indicates the timebase (time per di-

vision on the horizontal axis) and

sampling rate (sampling interval).

This setting can also be made on

the Status Settings screen.

Recording Length

Shows the recording length and time. The

recording length (duration) for each data

acquisition is set as a number of divisions.

This setting can also be made on the Sta-

tus Settings screen.

Magnification (⇒ p. 204)

Sets time (horizontal) axis magni-

fication/compression of the whole

waveform.

You can select [Mag] to display

the whole waveform on one

screen.

Trigger Mode Setting (⇒ p. 132)

Sets subsequent triggering criteria after a

measurement operation is finished.

(These settings are made on the Trigger

Settings screen.)

Pre-Trigger Setting (⇒ p. 134)

Set this to record data prior to a trig-

ger event, or for a specified period

afterwards.

Selectable when the Overlay

function is enabled. (

⇒ p. 101)

Zoom (⇒ p. 206)

Sets the time (horizontal)

axis magnification ratio of

the selected section of the

waveform.

Recording

Duration

Sampling Rate

See "4.4 Setting Measurement Configuration on the Waveform Screen" (⇒ p. 108), "6.12 Making Trigger Settings on

the Waveform Screen" (⇒ p. 161)

With the Memory Function

With the Recorder Function

Switch with the SUB MENU keys

To view waveforms during real-time printing,

stop and then restart printing. (

⇒ p. 302)

The setting procedure is the same as that for the

Memory Function. Selection items are different.

Setting Item