User Manual

Appendix 5 Options
A53
Appendix
Measurement Probes, Cables and Clamps
Maximum
input voltage
For Voltage Measurement
Model 9197 Connection Cord For high voltage 500 V
Model 9198 Connection Cord For low voltage 300 V
Model 9217 Connection Cord Isolated BNC-BNC 300 V
Model 9322 Differential Probe
For high voltage
Following item is required for connec-
tion.
• Voltage measurement with an input
module other than the Model 8958
16-Ch Scanner Unit requires the
Model 9418-15 AC Adapter
*2
or 9248
Power Cord (when using the Model
9687)
*3
• Connecting the Model 8940 F/V Unit
requires the Model 9325 Power
Cord
*1
, 9418-15 AC Adapter
*2
, or
9248 Power Cord(when using the
Model 9687)
*3
(CAT II)
2000 V DC,
1000 V AC
(CAT III)
600 V AC/DC
Model 9665 10:1 Probe
Maximum rate voltage above
ground is that of the input module.
1 kVrms
(up to 1 MHz)
Model 9666 100:1 Probe
Maximum rate voltage above
ground is that of the input module.
5 kVpeak
(up to 1 MHz)
*1. Model 9325 Power Cord
For Model 9322, connect to the sensor terminal on the
Model 8940
*2. Model 9418-15 AC Adapter For Model 9322
*3. Model 9248 Power Cord For connecting the Model 9322 and 9687
For Logic Signal Input
Model 9320-01 Logic Probe
Four channels, for detecting voltage and closed/open
contact points
Model 9321-01 Logic Probe
Four isolated channels, for detecting AC/DC voltage on/
off (for small terminal types and for lines)
Model 9327 Logic Probe
Four channels, for detecting voltage and closed/open
contact points (high-speed type)