User Manual

3.1 Measurement Workflow
53
7
3
Chapter 3 Operation Overview
Display Sheet Settings*
Set on the Sheet Settings screen (⇒ p. 168).
(Make these settings to change the Waveform
screen layout)
See
• To optionally assign measurement data to Sheets
(
⇒ p. 169)
• To change Sheet names (⇒ p. 171)
• For X-Y composite measurements (⇒ p. 180)
Screen Layout Settings (⇒ p. 171)
Split-Screen Number and Pattern Settings
(⇒ p. 172)
Displayed Channel Settings (⇒ p. 174)
Save Settings
Set on the Save Settings screen (⇒ p. 243).
(Make these settings to save data)
To save automatically while measuring, be sure to make
these settings before starting.
See
• About saving methods (⇒ p. 252)
Auto or Manual Save Settings
Save Contents Setting
Print Settings
Set on the Print Settings screen (⇒ p. 297).
(Make these settings when you want to print data.)
To print automatically while measuring, be sure to make
these settings before starting.
See
Using an external printer (
⇒ p. 299)
Auto or Manual Print Settings
Print Content Settings
Start Measurement
Press the START key (⇒ p. 75).
Data Acquisition
Save & Print (when Auto enabled)
End of Measurement
Press the STOP key to stop (⇒ p. 75).
Press twice to stop immediately.
If [Single] trigger mode is selected, recording stops
automatically after acquiring the specified data length.
Data Analysis
Analysis on the waveform screen (⇒ p. 185).
See
(Memory Function)
• To calculate numerical values (Analysis Supplement )
• For X-Y composite (
⇒ p. 180)
• To search waveform data (
⇒ p. 215)
• To calculate waveform data (Analysis Supplement )
• To perform FFT calculation (Analysis Supplement )
Waveform Scrolling (⇒ p. 186)
Cursor Measurements
(⇒ p. 195)
Magnification/Compression and Zoom
(⇒ p. 204)