User Manual

3.1 Measurement Workflow
55
7
3
Chapter 3 Operation Overview
3.1.2 Logic Waveform Recording
To simultaneously record logic waveforms, see also "3.1.1 Analog Waveform Recording" (⇒ p. 51).
Procedure (asterisks (*) indicate settings that
can be changed while measuring)
Overview and references
Installation & Connection
Connect the logic probes.
See "2.6 Connecting Logic Probes" in the Input Module Guide
Power On
Measurement
Configuration Settings*
Set on the Status Settings screen.
Timebase Setting (⇒ p. 89)
Recording Length Setting (⇒ p. 95)
Set Channels to Use (⇒ p. 85)
Enable (turn on) the channels to use (With Memory function).
Input Channel
Settings*
Set on the [Logic] page of the Channel Settings
screen.
Set Waveform Display On/Off (⇒ p. 177)
Set waveform display for each channel probe on or off.
(Default setting: Off)
Set Waveform Display Color (⇒ p. 177)
Set as occasion demands.
Trigger Settings*
Set on the [Logic] page of the Trigger Settings
screen (
⇒ p. 129).
(Make these settings to record a specific waveform, such as an anom-
aly: enable triggering)
Trigger Mode Setting (⇒ p. 132)
Trigger Criteria Settings (⇒ p. 133)
Logic Trigger Settings (⇒ p. 153)
Display Sheet Settings*
Set on the [Logic] page of the Sheet Settings screen.
Set Display or Non-Display (⇒ p. 177)
Enable (set On) the channels to be displayed.
(Default setting: On)
Set Display Positions (⇒ p. 178)
Set for each channel as occasion demands.
(Default settings: Position 1, 2, … beginning with Lch A)
Set Display Height (vertically) (⇒ p. 179)
Set as occasion demands.
(Default setting: Normal)
From here, proceed the same as for analog channels. Refer to "Save Settings" (⇒ p. 53).