User Manual

79
4
Chapter 4 Measurement Configuration Settings
Measurement Configuration
Settings Chapter 4
1
Open the Settings screen
2
Menu selection
Basic measurement configuration settings are performed on the Status Settings screen. Measurement
configuration can be performed from the Waveform screen (⇒ p. 108).
About screen contents:
"2.5.1 Status Settings Screen" (
⇒ p. 27)
3
Page selection
Measurement Configuration Settings Available on the Status Setting Screen
Function Selection (⇒ p. 80)
• Memory Function
• Recorder Function
Measurement Configuration Settings
• Timebase or Sampling Rate setting (⇒ p. 89)
• Recording Length setting (
⇒ p. 95)
To measure using different sampling rates
• Timebase 1 and Timebase 2 sampling rate
settings (⇒ p. 92)
To control sampling by an external signal
input
• External Sampling setting (
⇒ p. 394)
Set Channels to Use
• Setting the number of channel to use (⇒ p. 85)
• Setting different sampling rates (⇒ p. 93)
• Setting which channels to use (
⇒ p. 85)
Utility Function Settings
• View waveforms while acquiring data (Roll
Mode) (
⇒ p. 99)
• Waveform Overlay (
⇒ p. 101)
• Record by memory divisions (⇒ p. 103)
(set on the Memory Division Setting screen)
• Real-Time Saving Function (
⇒ p. 225)
• FFT Function (Analysis Supplement )
Memory Function
Measurement Configuration Settings
• Timebase setting (⇒ p. 89)
• Sampling Rate setting (
⇒ p. 89)
• Recording Length setting (
⇒ p. 95)
Recorder Function