User Manual

4.2 Setting Measurement Configuration (Status Settings Screen)
86
2
3
Logic Channels
: On
: Off
(Model 8861 case)
Operating Key Procedure
1
SHEET/PAGE
Select the [Use Ch] page.
2
Select the number of channels to use.
CURSOR
Move the cursor to the [Timebase1] item.
F1 to F8
Select the number of channels to use.
When using logic channels:
LOGIC terminals CH A through CH D are repre-
sented as one channel.
For the Model 8861 case:
The total number of usable channels is twice the
number of selected channels. However, the num-
ber of channels enabled for use in the upper tier
(Units 1 to 4+ and Logic A to D) and lower tier
(Units 5 to 8) cannot exceed the specified num-
ber of channels.
3
Select the channels for measurement (analog/logic
inputs).
CURSOR
Move the highlight cursor to a channel to be set.
F1 to F8
Select either choice.
1CH, 2CH, 4CH, 8CH (default setting) or 16CH
(The default setting depends on installed input mod
-
ules.)
Off No measurement
On Use for measurement (default setting)
Setting Channels to Use: Using input modules
other than the Model 8958 16-Ch Scanner Unit
To open the screen: Press the SET key → Select with the SUB MENU keys →Status Settings screen
See Screen Layout (
⇒ p. 27), To set from the Waveform screen (⇒ p. 108)
Number of Channels to Use
1
About the Number of Channels
When [8CH] is selected with Model 8861:
Up to eight channels can be used in each
of the upper and lower tiers. (Total number
of usable channels (8CH × 2 = 16 chan-
nels)
Input Module and Channel Nos.