User's Manual

........................................................................... 7 | Page
Connecting To Your Network
n Extend the antenna on the rear of your radio.
Press the button to power-up BLIK
Radiostation.
n After a few seconds this message will change
to a welcome message.
n For initial use, Press button to scroll
up and down each mode or simply press
MODE button to enter.
n Press button to select INTERNET
RADIO, and press the SELECT button. Then
the display will show a list of region for your
choice.
n In some cases BLIK Radiostation may find
more than one network. Use the
buttons to see the names of each one – and
press the SELECT button when the name of
your own network is displayed.
n If your network is not configured to request a
password (WEP/WPA), BLIK will connect to
the network and display:
n If a WEP/WPA key (password) is required,
BLIK will display the following:
n After a few seconds, BLIK will ask you to input
the WEP/WPA code and will display the
password entry screen as follows:
n Use the buttons to cycle back and
forward through the alpha-numeric character
list. Press the SELECT button to select a
character.
Please note: WEP/WPA pass codes are
case-sensitive.
n If you make a mistake while entering your
password, select icon to delete a
character.
n Select for last or next line
n Select icon for return.
n After selecting the final character of your
password, scroll to the icon and press the
SELECT button to enter your code. BLIK
Radiostation should now successfully connect
to your network.
n BLIK Radiostation will automatically
remember the WEP/WPA code for your
network, and other networks you have used
previously. You will not need to re-enter these
codes in the future.