User Manual

System 1000

Power Vent Controller

Programming Guide

Sample Setup

This section is given as an example of how to program the controller for your

individual needs. For this example the house is set up with one controller

operating two power units. Each power unit controls the vents on its respective

side.

Fans

Power UnitsVents Vents

In the above example, one controller is operating two power units. Each

When programming the controller, you should scroll through the menu with the

Select Features up arrow. When you do this, you will see a statement or

question. These statements are known as prompts. You then use the Change

setting up and down arrows to answer these prompts. Here is an example:

Prompt Answer

Ramp function Yes

*Hi end temp 80

*Hi end press .0400

*Lo end temp 30

*Lo end press .0900

Synchronize **Yes

Clock Set time

High Pressure Alarm on Yes

*High pressure .1500

Low Pressure Alarm on Yes

*Low pressure .0000

Timer fan pressure alarm Yes

*Minimum pressure .0200

*Timer period 10 min

*Auto reset alarm No

Differential .0100

Calibrate Temperature If needed

Vent Time Delay Yes

*Delay Seconds 40

• The prompts with an asterisk will not appear when the feature immediately

preceding is answered "No".

• ** Used only when one controller is operating two power units. If only one

power unit is used, answer "No" to this prompt.