Datasheet

2
■ Product Specifications
*V.S.W.R. Measurement System
The above V.S.W.R. standard values were measured using the measurement system of the diagram below.
NOTE 1: Cable type connectors were measured with SMA conversion adapters
attached to both ends of the harness product of a suitable 100-cm cable.
NOTE 2: Board type connectors were mounted to a 50Ω glass epoxy board and
measurements were conducted with SMA conversion adapters attached.
Ratings
Nominal characteristic impedance 50ø
Rated voltage 60 V AC (rms)
Rated frequency DC to 6 GHz
Operating temperature range -40˚C to +90˚C
Operating humidity 90% max.
Item
Specification
Conditions
1. Contact resistance
Center: 20 m
ø max.
Outside: 10 m
ø max.
Dia.0.81Cable 1.35
Dia.1.13Cable 1.4
Dia.1.32Cable 1.5
3 to 6 GHz
Measured at 10 mA max.
2. Insulation resistance
3. Withstand voltage
4. V.S.W.R.*
5.
Female contact holding force
6. Repetitive operation
7. Vibration
8. Shock
9. Humidity resistance
9. (Steady state)
10. Temperature cycle
11. Salt spray test
500 Mø min.
No line or insulation breakdown
1.3 max.
0.15 N min.
Contact resistance
25 m
ø max. (Center)
15 mø max. (Outside)
No momentary disconnections of 1 µs min.
No damage, cracks, or parts looseness min.
No momentary disconnections of 1 µs min.
No damage, cracks, or parts looseness
No damage, cracks, or parts looseness
Insulation resistance 100 M
ø min.(High temperature)
Insulation resistance 500 Mø min.(Pry)
No damage, cracks, or parts looseness
Contact resistance 25 mø max. (Center)
15 mø max. (Outside)
No excessive corrosion
Measured at 100 V DC
200 V AC for 1 minute
DC to 3 GHz
Measured with a Ø 0.475 pin gauge
30 cycles of insertion and disengagement
Frequency of 10 to 100 Hz, single amplitude of 1.5 mm,
acceleration of 59 m/s
2
, for 5 cyles in the direction of each of the 3 axes
Acceleration of 735 m/s
2
, 11 ms duration, sine half-wave
waveform, for 6 cycles in the direction of each of the 3 axes
Temperature of 40˚C, humidity of 95%,
let stand for 96 hours
Temperature: +40˚C
/
5 to 35˚C
/
+90˚C
/
5 to 35˚C
Time: 30 min.
/
Within 5 min.
/
30 min.
/
Within 5 min.
Cycles: 5
48 hours continuous exposure to 5% salt water
Part Material Finish Remarks
Shell
Phosphor bronze Silver plating —————
Male center contact Brass Gold plating —————
Female center contact
Phosphor bronze Gold plating —————
Insulator
Plug Black UL94V-0
Receptacle Beige UL94V-0LCP
PBT
■Materials