User Instructions

17
2) Lappareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptibleden compromettre le fonctionnement.
The system integrator must place an exterior label on the outside of the final product housing the
AEH-W4F1 Modules. Below is the contents that must be included on this label.
OEM Labeling Requirements:
NOTICE: The OEM must make sure that FCC labeling requirements are met. This includes a clearly
visible exterior label on the outside of the final product housing that displays the contents shown in
below:
Model: AEH-W4F1
Contains FCC ID: 2AGCCAEH-W4F1
Contains IC: 20778-AEHW4F1
5.8 Information on test modes and additional testing requirements:
When testing host product, the host manufacture should follow FCC KDB Publication 996369 D04
Module Integration Guide for testing the host products. The host manufacturer may operate their
product during the measurements. In setting up the configurations, if the pairing and call box options
for testing does not work, then the host product manufacturer should coordinate with the module
manufacturer for access to test mode software. For wireless LAN, the product under test is set into a
link/association with a partnering WLAN device, as per the normal intended use of the product. To ease
testing, the product under test is set to transmit at a high duty cycle, such as by sending a file or
streaming some media content. Alternatively, a Wi-Fi test set may be used. Simultaneously transmitting
modules installed in the host should be all active.
5.9 Additional testing, Part 15 Subpart B disclaimer:
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part 15.247) list on the
grant, and that the host product manufacturer is responsible for compliance to any other FCC rules that
apply to the host not covered by the modular transmitter grant of certification. The final host product
still requires Part 15 Subpart B compliance testing with the modular transmitter installed when contains
digital circuity.