User's Manual

Basic operations
14
1. Press [CH ] button on the remote control, you can change the channels.
(Press [VOL ]button to raise or lower the volume).
2. Press [CH ]button on the front panel of the TV set, you can also change the channels.
(Press [VOL ] button to raise or lower the volume).
3. Press the numeric buttons on the remote control to display the corresponding channels.
Note:
Changing the channels can also be achieved by directly pressing the programme No. If you want
to choose the programme No. from 1 to 9, press the numeric buttons directly. If you want to select
a programme No. that double-digit or three-figure, the time between twice pressing the numbers
should not be more than 3 seconds.
/
/
Changing Channels/ Volume
/
/
Select input source
Change picture mode
Change sound mode
Still picture
Mute sound
Set sleep timer
Choose the current input signal of the main picture. First press [Source] button to display the signal
inputs. Press [ ]button to select the source you wanted to enter, then press [ ] button
to confirm.
/ /OK
It can be set as Normal, Vivid, Sports, Movie, Game and User. This mode achieves a certain image
display effect by setting the brightness, contrast and color etc.
It can be set as Normal, Rock, Jazz, Classic, Pop and User. This mode achieves a special sound
effect by setting equalizer.
Press [Still] button that moving picture will become a still one.
Press [Mute] button to turn the sound off, press this button again to turn the sound back on. This
function is used to switch off sound temporarily.
It can set the TV to let it enter into the Standby state automatically, Press this button repeatedly to
select the proper sleeping clock mode, and the clock tells you the remaining time before the TV
enters Standby state.