Installing Batteries in the Remote Control « Change the batteries 1. Slide the back cover to open the battery compartment of the remote control, 2. Insert two ARA size baptisteries. Make sirs to mach ths and { } ends of the batteries with the and { } ends Indicated In the battery compartment. 3. Close the battery compartment cover. The remote control requires: €@ Gently push and slide Insert the batteries € Gently push and slide % Number of Batteries: Type: AAR & © Voltage: 1.5Vee (ESE .
Making connections & Cheek the jacks for position and type before making any connections. Loose connections can result in image or color problems. Make sure that all connections are tight and secure. B Mot all A/V devices have the ability fo connect to a TV, please refer to the user manual of your AV devices for compatibility and connections procedures. % Always unplug the power cord when connecting external equipment, » Connecting an antenna, cable or cable/sateliite box 1.
= Connecting an AJV Device with Component Cable 1. Use a component cable to connect the lexical AV device's component output jacks io the TV's YP,P;, jacks. Use an audio cable to connect the textual AV device's component audio jacks to the TV's AUDIO (LR) jack. 2. Plug the connected devices Into the mains socket before switching on the TV. 3. Select the corresponding source from the TV. TV JACK EXTERNAL DEVICES Audio Cable Bed (not included) nl Porgy, .
= Connecting an Audio Receiver with Audio cable 1. Use an audio cable fo connect the AV device's digital audio in jack to the TV's DIGITAL OUTPUT jack. Or uss an RCA Y-cable mini to LR phone not provided) to connect analog sound system to the TV's AUDIO OUT jack. 2. Plug the connected devices into the amine socket before switching on the TV. 3. Slacks the corresponding source from the TV. TV JACKS EXTERNAL DEVICES RU.
Turning Your TV On or Off Te tum your TV en or off (standby mode): 1. Play the power cord info an AC power outlet. 2. Press [POWER] button. Your TV tums on. 3. Press [POWER] button again to tum off your TV. When you tur off your TV, if goes Into standby mods. When your TV is in standby mods, if is sell receiving power. To completely disconnect power, unplug the power cord. If your TV doss not receive an input signal for severs! minutes, i automatically gods into standby mode.
Selecting the Input Source The first dime you tum on your TV, you must select the TV signal sources. Your TV stores this Information, so you do not need fo change the TV signal source unless & changes. For example, you change from an outside antenna to cable TV. To select the video input rouses: 1. Tum on your TV, then press [INPUT] button on the remote ar on the TV. The Input source menu opens. 2. Press button to highlight the input source, then press [ENTER] bunion. Changing Channels / Volume 1.
To Use the Menu Crass [MEN] to open the main menu. 2 Press [4/9] fo select a menu option, then press [B/ ENTER] button to enter the menu. 3 in each menu, you can: Press [4/9] to select an item, Crass [4/b] to adjust the values, or Press [I /ENTER] to enter the sub menu, Press MENU] to back tha previous menu. 4 Press [EXIT] to exit the menu. Standard finial cal » gre > The menus in the user manual may vary slightly from the actual screen.
Using the Audio Menu You can adjust: Sound Mods Select the Sound Mode: Standard, Theater, Sirius, Speech or Custom. Balance Adjust the volume of the loft and right speakers. Equalizer Soften or enhance the sound at specific frequency points. Lute Volumes Control Automatically adjusts volume fo a consistent vela; attenuates loud passages, TY Speakers Selects where to play TV audio.