User's Manual

11
Getting Started
1. Make sure that you have:
Installed the remote control batteries.
Connected an antenna, cable or CATV/SAT set-top-box
PVR.
Connected the power cord.
2. Press [POWER ] button to turn on your TV.
3. The
Setup Wizard
menu displays. Follow Step 1 through
11 in the Setup Wizard menu procedure.
IMPORTANT: If you have not yet paired the remote to the
TV, please refer to the section titled Pairing the Remote
in this manual.
To turn your TV on or off (standby mode):
1.
Plug the power cord into an AC power outlet.
2.
Press button, your TV turns on.
3.
Press button again to turn off your TV. When you turn
off your TV, it goes into standby mode.
The Setup Wizard menu appears the first time you turn on
the TV. The wizard will guide you step-by-step through the
initial setup and configuration of your television.
IMPORTANT: Make sure that the antenna or cable is
connected and a wired or wireless Internet connection is
available.
Turning the TV On for the First Time
Turning the TV on or off
NOTES
When your TV is in standby mode, it is still receiving
power. To completely disconnect power, unplug the power
cord.
It may take 15-20 seconds for the TV to be ready after
pressing the power button.
NOTE
[CH +/-] button can be used in ANT/CABLE mode only.
1. Press the [CH +/- ] button on the TV/remote control to
change the channel.
2. Press the [VOL + /- ] button on the TV/remote control to
adjust the volume.
3. Press the [...] button to display numeric menu, then
select digit channel number to display the corresponding
channels.
Changing Channels / Volume
Follow the on-screen instructions to customize your TV
settings according to your preferences.
Pairing the remote control.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 7
Step 6
Step 8
Step 9
Step 10
Step 11
Selecting Home or Retail.
Connecting to the DLNA device.
Selecting menu language.
Hisense legal information.
Connecting to the Internet via
Ethernet cable or WiFi.
Signing in with your Google
Account.
Check the TV to send the
usage statistics and crash
reports to Google automatically.
Enter ZIP code so that you
receive accurate programming
information.
Select the video input you use to
connect your TV service to your TV.
Select your Audio amplifier
manufacturer. To control your
receiver, connect the IR blaster.
The initial settings are completed.
Pairing remote
controller
Select usage
patterns
DLNA setting
Select menu
language
Legal notice
Connect to the
Internet
Google Account
Help make
Google TV better
Enter ZIP code
Set up TV service
Set up AV
Receiver control
That’s it!
Setup Wizard