User's Manual

13
Pair up With The Subwoofer
Automatic pairing
Plug the soundbar and the subwoofer into the
mains sockets and then press on the unit or
remote control to switch the unit to ON mode.
The subwoofer and soundbar will automatically
pair.
t When the subwoofer is pairing with the main
t When the subwoofer is paired with the main
unit, the Pair Indicator will light up.
NOTE:
- Do not press the Pair button on the
subwoofer, except for manual pairing.
- If the automatic pairing fails, pair the
subwoofer with the main unit manually.
Manual pairing
If no audio from the wireless subwoofer can be
heard, manually pair up the subwoofer.
1 Power up Sound bar by remote control or
touch pad.
Press Sound bar SOURCE key for 5 seconds
until the screen shows “SUB PAIRING”. It is
connected when the LED of subwoofer turns
to normal.
2
.
3
NOTE:
t The subwoofer should be within 6 m of the
soundbar in an open area (the closer the
better).
t Remove any objects between the subwoofer
and the soundbar.
t If the wireless connection fails again, check
(e. g. interference from an electronic device)
or strong interferences and repeat the above
procedures.
t If the main unit is not connected with the
subwoofer and it is in ON mode, the unit’s
Basic Operation
Standby/ON
socket, the main unit will be in Standby mode.
t Press the
button on the unit or on the
remote control to switch the unit ON.
t Press the
button again to switch the unit
back to STANDBY mode.
t Disconnect the mains plug from the mains
socket if you want to switch the unit OFF
completely.
t Auto Wake
If a TV or an external device is connected, the
unit will switch on automatically when the TV
or the external device is switched on.
t Auto Standby
The unit automatically turns to Standby mode
after about 15 minutes if the TV or the external
t
mains plug from the mains socket.
t
energy when not in use.
Select Modes
Press the
(SOURCE) button repeatedly on the
unit or the SOURCE button on the remote control
to select the OPTICAL,COAXIAL, ARC,HDMI IN,
BT_IN(Bluetooth) and USB mode. The selected
mode will show on the display.
Adjust the Bass/Treble Level
t Press TREBLE then press VOL+/- button to
increase or decrease the treble.
(treble+5 / treble–5)
t Press BASS then press VOL+/- button to
increase or decrease the bass.
(bass+5 / bass–5)
t After about 5 seconds, the unit will exit from
bass/treble setting. The display will show the
current selected mode. You may now press the
VOL+ / - buttons to adjust volume.
Power up subwoofer and press Pair key for
3 seconds until the LED turn to fast flashing
from slow flashing. Please disconnect the AC
power and connect again after 5 minutes to
reset the subwoofer.