Dimensions Guide

PRODUCT MODEL NUMBERS

HMO173SR

Over the range microwave oven

ELECTRICAL REQUIREMENTS

Required:

■ A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply with

a fuse or circuit breaker.

Recommended:

■ A time-delay fuse or time-delay circuit breaker.

INSTALLATION DIMENSIONS

■ A separate circuit serving only this microwave oven.

PRODUCT DIMENSIONS

Hisense

Cabinet

Splash guard

66" or more from

the ﬂoor to the top

of the microwave

NOTE

S :

The space between the cabinets must be 30" wide and free of obstructions.

If the space between the cabinets is greater than 30",you'll need

ﬁller material to ﬁll the gap between the microwave oven and the cabinets.

This microwave oven is for installation over ranges up to 36" wide.

If you are going to vent your microwave oven to the outside, see Hood Exhaust Section for exhaust duct preparation.

When installing the microwave oven beneath smooth and ﬂat cabinets, be careful to follow the instruction for power cord clearance. Make

sure that you leave enough space for the power cord clearance.

16 7/8″

42.88cm

29 7/8″

75.79cm

17 7/8″

45.29cm

•

PAGE 1
Hisense Over the range microwave oven PRODUCT MODEL NUMBERS INSTALLATION DIMENSIONS HMO173SR ELECTRICAL REQUIREMENTS Required: ■ A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply with a fuse or circuit breaker. Recommended: Cabinet ■ A time-delay fuse or time-delay circuit breaker. ■ A separate circuit serving only this microwave oven. Splash guard PRODUCT DIMENSIONS Cabinet 16 7/8″ 42.88cm 66" or more from the ﬂoor to the top of the microwave 17 7/8″ 45.29cm 29 7/8″ 75.