CONTENTS Safety information Control panel Operation Maintenance Customer service and spare parts Electrical connection Installation What to do if... Environmental concerns 1 3 3 5 6 6 6 10 10 SAFETY INFORMATION of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. It is dangerous to alter the specifications or modify this product in any way.
adhered to. Refer to relevant instructions. The inner lining of the appliance has channels through which the refrigerant passes. Should the channels be punctured the unit would be damaged beyond repair. DO NOT USE SHARP INSTRUMENTS to scrape of frost or ice. Frost may be removed by using a scraper. Under no circumstances should be solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. qualified electrician or competent person.
Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gasses: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger.
Bottle “Light On” Bottles can be illuminated in different ways. Keep the wine in the dark. The door is in anti-UV darkened triple glass to protect the wine from the light in case the refrigerator is located in well-lit place. 1. The interior light will be on automatically for 5 minutes when the wine refrigerator is powered on. Lay the bottles down in such a way that the corks do not dry. 2. The interior light can be turned on or off by pressing the light On/Off key.
intended Lamps must be replaced by authorized service agents only.
CUSTOMER SERVICE AND SPARE PARTS If the power cable is damaged, it must be replaced immediately by an authorized service agent. If the appliance is not functioning properly, check that: The plug is firmly in the wall socket and the mains power switch is on; There is electricity supply (find out by plugging in another appliance); If there are water drops on the bottom of the cabinet, check that the defrost water drain opening is not obstructed (see “Defrosting” section).
Door reversibility Before carrying out any operations, remove the plug from the power socket. To change the opening direction fo the door, proceed as follows: 4. Remove the two screws and take the handle off. Put the handle in a safe place. 1. Remove the two screws at the rear of the top cover. 2. Push the top cover forward until it is free. And move the small plate from left to right. Then put the top cover on a safe place to avoid scratch. 5. Move the hole covers from the left side to the right side.
10.Lay the appliance on a soft rug or similar article to protect it. Unscrew and remove the lower hinge pin and install it to other hole. 11.Unscrew the screws that fix the lower hinge and take the lower hinge with foot off. 8. Rotate the door, remove the screws of the stopper. Reinstall the stopper on the opposite side of the door using the same screws. 12.Move the foot from left to right and fix it in right hole show in below picture. 13.Fix the lower hinge with screws on the opposite side. 9.
15.Put the door on the lower hinge. Holding the door against the cabinet insert the pin of the hinge in the door. The right and left sides of the door must align with the sides of the cabinet. And then securely fix the upper hinge. Levelling The appliance should be leveled with a small inclination backward to help the closing of the door. Four adjustable feet are provided for that purpose. All four ground for stability and to reduce vibration.
WHAT TO DO IF... Warning: Before troubleshooting, disconnect the power supply. Troubleshooting other than that listed in the table below must only be carried out by an authorized service agent. Malfunction Important: Noises from the compressor and refrigerant circulation during operation are normal and do not indicate malfunction. Possible cause Remedy Temperature is not properly adjusted. Please look in the “Use” section. Door was open for an extended period. Open the door only as long as necessary.
and
WARRANTY CLAIMS PROCEDURE Please retain this portion for your records 36 MONTHS RETURN TO SERVICE CENTRE WARRANTY - For items with a 130 litre capacity or less Upon calling the Hisense Australia Warranty Centre, you will be issued a JOB NUMBER, along with the details of your nearest Hisense Authorised Service Centre to return your item for warranty repair. 36 MONTHS IN HOME REPAIR WARRANTY Hisense Australia will provide its nearest service centre for repairs under warranty.