Operation Manual

Main Source

: Move

OK : Select

Analog TV

Digital TV

VID/SVID1

VID/SVID2

Component1

Component2

HDMI1

HDMI2

HDMI3

Power ON/OFF

ØTurning on: Connect the TV an AC power outlet and turn on the power switch located below the front right hand

side of unit. The power indicator will be initial red and then will change to blue. A few seconds later image will appear

on the screen.

ØTurning off to standby mode: Press the [ ]button on the front panel or on the remote control to switch standby

mode. You can activate the unit again by pressing the [ ] button.

ØPower indicator:

Red indicates standby mode.

Blue shows that the unit is on.

There will no light when the power switch is in off position.

Notes:

Turn the power switch off when you do not intend to use the TV for long periods, for example overnight. Remove the

connection from the wall power outlet if you do not intend to use the unit for longer periods, for example if you plan to

be away a few days.

Wait at least 5 seconds after turning off if you want to re-start the TV.

Signal source selection

[SOURCE] button: Press the [SOURCE] button and press [P+/P-] button to select signal input, press [OK] to confirm

selection.

[HDMI] button: press [HDMI] button to select HDMI signal input.

[YPBPR] button: press [YPBPR] button to select Component signal input.

[D/A] button: press [D/A] button to switch Digital/Analog signal input.

Select channels

You can select channels by press [P+/-] on the remote or press [CH / ] on the front panel

of TV.

Select channels by numbers

Input channel numbers sequentially to select channels by program numbers.

For example, to select channel 120, press the button 1, and 1will be displayed on the top right corner of the screen,

then press the button 2, 12 will be displayed, press the button 0, channel 120 will now appear on screen.

[VOL ] or [VOL ]

Adjust Volume

Press on the front panel of TV or press [v-/v+] on the remote to adjust volume.

Use [LAST] button

Press [ LAST ] button repeatedly to alternate between the present program and the previous in both the

same and different signals source.

program