Operation Manual
Cleaning and care
WARNING: Do not try to remove the cabinet back. Refer servicing to qualified service technicians.
To clean the TV screen:
1) Unplug the TV to avoid possible shock hazard.
2) Use a clean cellulose sponge or chamois cloth dampened with a solution of mild detergent and warm water to clean the
TV screen and trim. Do not use too much water as water spilled into the cabinet can cause damage to the TV.
3) Wipe off any excess moisture with a clean dry cloth.
Caution:
Never use strong solvents such as thinner, benzene, or other chemicals on or near the cabinet.
These chemicals can damage the finish of the cabinet.
Before calling a service technician, please check the following table for a possible cause of the problem andsome solutions.
Troubleshooting
TV will not turn on
Make sure the power cord is plugged in, then press [Power].
The remote control batteries may be dead. Replace the batteries.
No picture, no sound
Check if you have set the off timer.
Check the antenna/cable connections.
Press [Display] to see if you have selected the right signal.
No sound, picture OK
The sound may be muted. Press [Mute] on the remote control.
The station may have broadcast difficulties. Try another channel.
Check the speakers cable connections.
Poor sound, picture OK
The station may have broadcast difficulties. Try another channel.
Check the speakers cable connections.
Poor picture, sound OK
Check the antenna connections.
The station may have broadcast difficulties. Try another channel.
Adjust the picture from the menu, Antennae may need to be adjusted or replaced.
Unable to select a certain channel
The channel may be skipped. See Skip on page 16.
Poor color or no color
The station may have broadcast difficulties. Try another channel.
Adjust the HUE and color in the menu.
The remote control does not operate
There may be an obstruction between the remote control and the remote
control sensor.
The batteries may be installed incorrectly.
The remote control batteries may be dead. Replace the batteries.
Disorder display at power on
This may be caused by too short interval between power off and on.
Unplug the power wait 5 minutes and restart.
25