RB327N4WB1 RB327N4WC1 RB327N4WW1
15 8 16 Reversing the door_ _ _ _ _ _ _ _ _ _ _ 9 17 12 18 13 19
Children should be supervised to ensure that they do not play with the appliance.
The symbol is a warning and indicates the refrigerant and insulation blowing gas are flammable.
1120-1140 607-627 135 940 climate class from SN to ST showed in the
to the left side,if required.
① ② the lower hinge part by unsrewing the special flange self-tapping screws.
.Replace the lower hinge part to the left self-tapping screws. Replace the adjustable bottom feet parts to another side and fixing it. 15. Transfer the upper hinge part and 12.Transfer the lower door to the property 13.Upturn the middle hinge part the direction 180 degree, adjust its position, change the washer on the axis to the lower side, make the middle hinge axis 16. Install the srew hole cover on the top 17. Open the upper door and install the 14.
2. LED light 3. Wind channel cover in refrigerator Fridge 4. Refrigerator shelf Vegetable drawer cover Vegetable drawer Wind channel cover in freez er .Freezer tray 10. Middle freezer drawer 11 .Lower freezer shelf 12. Fridge door 15. Upper door shelf 16. Egg tray( inside) Middle door shelf Water tank 19. Lower door shelf 23.
Install the door shelf ly a rd s pre w s in Firstly tilt the left side of the door shelf ,and make sure the notch has been fastened to the door .Then press the right side inwardly ,push it down to the right place. Accessories 2) It is only applicable to RD-33WC4SLB/CPA1-001. Remove and install the door shelf Warning:The door shelf must not removed and installed by the user! If the door shelf is damaged ,contact the customer helpline for assistance .
Before usingyour Using ●Before appliance using this appliance for the first time, you should use it based on following instructions. 1. Hold the two sides of the water tank tightly, then pull up the water tank by shaking up and down. 2. Unscrew the head, then clean it and the inside of water tank. Filling water 1. Open the water supply inlet cover from the left side. 2.Fill the water. ① ② Caution! ●Fill dispenser part Assembling ●Before assembling, please drain the water inside the tank. 1.
Warning! Don't push the dispenser lever forward without cup, it may cause the water leak from the dispenser. Cleaning 1.Clean the tank and dry it by natural drying or using the dryer. 2.If you have used the water dispenser for many times, the water in the receiving tank may drop on the floor, which may make your floor wet, and you should clean the tank with dry towel regularly before overflow. 1.Insufficient refrigeration in chamber. set the temperature controller at “colder”. 2.
Helpful hints and tips Energy saving tips ●We recommend that you follow the tips below to save energy. ●Try to avoid keeping the door open for long periods. ●Ensure the appliance is away from any sources of heat (Direct sunlight, electric oven or cooker etc). ●Don't set the temperature colder than necessary. ●Don't store warm food or evaporating liquid in the appliance. ●Place the appliance in a well ventilated, humidity free, room. Please refer to Installing your new appliance chapter.
Cleaning and care For hygienic reasons the appliance (including exterior and interior accessories) should be cleaned regularly (at least every two months). Caution! The appliance must not be connected to the mains during cleaning as there is a danger of electrical shock. Danger of electrical shock! Before cleaning switch the appliance off and remove the plug from the mains socket. Exterior cleaning -Wipe the control panel with a clean, soft cloth.
Troubleshooting If you experience a problem with your appliance or are concerned that the appliance is not functioning correctly, you can carry out some easy checks before calling for service, please see below. You can carry out some easy checks according to this section before calling for service. Warning! Don't try to repair the appliance yourself.
Ensure food is placed within the appliance to allow sufficient A layer of frost occurs in the compartment ventilation. Ensure that door is fully closed. To remove the frost, please refer to cleaning and care chapter. You may have left the doors open too long or too frequently; or the doors are kept open by some obstacle; or the appliance is located with insufficient clearance at the sides, back and top. Temperature inside is Increase the temperature by following the "Control panel” too cold chapter.
220-240V~, 50Hz, R600a ; Hisense Service Help Line : 0844 346 0087
Hisense UK Ltd Unit 2 Meadow Court Millshaw Lane Leeds LS11 8LZ
