RB403N4EW1 RB403N4EY1 RB403N4EC1 RB403N4EC2
Contents Brief introduction……………………….2 Important safety instructions…………2 Installing your new appliance………...4 Description of the appliance………….9 Display controls……………………...
● Don't place hot items near the plastic components of this appliance. Frozen food must not be refrozen once it has been thawed out. ● Don't store bottled or canned drinks (especially carbonated drinks) in the freezer compartment. Bottles and cans may explode. ● Do not consume ice popsicles or ice cubes straight from the freezer as this can cause freezer burn to the mouth and lips.
Switch off the appliance and disconnect it from the mains power before you clean or move it. ●Never unplug the appliance by pulling on the electrical cord. Always grip the plug firmly and pull straight out from the socket to prevent damaging the power cord. ● Do not operate the appliance without the light cover of interior lighting. ● Any electrical component must be replaced or repaired by a qualified electrician or authorized service engineer. Only genuine spares should be used.
It may not work properly if being left at a temperature above or below the indicated range for a long period. Climate class Ambient temperature SN +10°C to +32°C N +16°C to +32°C ST +16°C to +38°C T +16°C to +43°C ●Stand your appliance in a dry place to avoid high moisture. ● Keep the appliance out of direct sunlight, rain or frost. Stand the appliance away from heat sources such as stoves, fires or heaters.
①Upper cover ②Upper hinge cover (right) ③Upper cover of upper door ④Corner cover 1 another part②(in the plastic bag)to the left side with screws③ .Put part② just detached back to plastic bag. 2 1 3 ① Door holder ② Stop block ③ Self-tapping screws 3. Take down the corner cover. ① ② ③ 3 4. Remove the screws ① , remove part②. and 6. Loose screws used to fix the middle hinge and remove middle hinge. Then remove the lower door.
10. Screw out lower hinge, change it to the near hole site, and then screw up and mount washer. ① ② ③ ① Door holder ② Stop block ③ Self-tapping screws 11.Just remount to the step 9,change part①to left and part②to right and then fix them with screws④ . Finally install part③. Lower hinge part (left) 1 2 8. Change screw hole covers on middle cover plate from left to right (as shown in figure below). 12. Move the lower door and adjust its position to align lower hole site and upper hinge axis.
14. Move the upper door to appropriate position, adjust part① and upper door, then fix part① by screws② . (Please hold upper door by hand when installing) 16.Reverse part① by 180°and install it onto the right corner of upper door, then mount part②. (both of which are taken down in step 2) 1 2 ② ① 17. install part① , and then install part② 2 1 15. Install part the upper hinge cover(which is in the plastic bag). 1 18. Open the upper door, mount door racks and then close it.
Description of the appliance 1.Cabinet 2.Display board part 3.KED light 4.Glass shelf 5.Crisper cover 6.Fruit and vegetables crisper 7.Upper freezer drawer 8.Upper freezer glass shelf 9.Middle freezer drawer(huge box) 10.Middle freezer glass shelf 11.Lower freezer drawer 12.Adjustable bottom feet 13.Fridge door 14.Egg tray(in the shelf) 15.Middle fridge door shelf 16.Lower fridge door shelf 17.Fridge door seal 18.Freezer door seal 19.
Description of the appliance 1.Cabinet 2.Display board part 3.KED light 4.Glass shelf 5.Crisper cover 6.Fruit and vegetables crisper 7.Crisper cover of Moisture 0 Cool 8.Moisture 0 Cool 9.Upper freezer drawer 10.Upper freezer glass shelf 11.Middle freezer drawer(huge box) 12.Middle freezer glass shelf 13.Lower freezer drawer 14.Adjustable bottom feet 15.Fridge door 16.Egg tray(in the shelf) 17.Middle fridge door shelf 18.Lower fridge door shelf 19.Fridge door seal 20.Freezer door seal 21.
Display controls Use your appliance according to the following control regulations, your appliance has the corresponding functions and modes as the control panels showed in the pictures below. When the appliance is powered on for the first time, the backlighting of the icons on display panel starts working. If no buttons have been pressed and the doors are closed, the backlighting will turn off.
3. Super Freeze 4. Holiday Super Freeze will quickly lower the temperature within the freezer so food will freeze vitamins and nutrients of fresh food and keep food fresh longer. ●Press the middle part of button for 3 seconds to activate the super freeze function. The light will come on. ● In case of the maximum amount of food to be frozen, please wait about 24 h. ● Super freeze automatically switches off after 26 hours .
Using your appliance You appliance has the accessories as the "Description of the appliance”showed in general, with this part instruction you can have the right way to use them. Door rack is suitable for the storage of eggs, canned liquid, bottled drinks and packed food, etc. Do not place too many heavy things in the racks ● The middle door shelf can be placed at different heights according to your requirements. Please take food out of the shelf before lifting vertically to reposition.
Helpful hints and tips Energy saving tips We recommend that you follow the tips below to save energy. ● Try to avoid keeping the door open for long periods in order to conserve energy. ● Ensure the appliance is away from any sources of heat (Direct sunlight, electric oven or cooker etc) ● Don't set the temperature colder than necessary. ● Don't store warm food or evaporating liquid in the appliance. ● Place the appliance in a well ventilated, humidity free, room.
Switching off your appliance If the appliance needs to be switched off for an extended period, the following steps should be taken prevent mould on the appliance. 1. Remove all food. 2. Remove the power plug from the mains socket. 3. Clean and dry the interior thoroughly. 4. Ensure that all the doors are wedged open slightly to allow air to circulate.
Door seals cleaning Take care to keep door seals clean. Sticky food and drinks can cause seals to stick to the cabinet and tear when you open the door. Wash seal with a mild detergent and warm water. Rinse and dry it thoroughly after cleaning. Caution! Only after the door seals are completely dry should the appliance be powered on. Replacing the LED light: Warning: The LED light must not be replaced by the user! If the LED light is damaged, contact the customer helpline for assistance.
Problem Possible cause & Solution Check whether the power cord is plugged into the power outlet properly. Check the fuse or circuit of your power supply, replace if Appliance is not working necessary. The ambient temperature is too low. Try setting the chamber correctly temperature to a colder level to solve this problem. It is normal that the freezer is not operating during the automatic defrost cycle, or for a short time after the appliance is switched on to protect the compressor.
Water drips on the floor The light is not working is preventing the doors from closing. The water pan (located at the rear bottom of the cabinet) may not be properly leveled, or the draining spout ( located underneath the top of the compressor depot) may not be properly positioned to direct water into this pan, or the water spout is blocked. You may need to pull the refrigerator away from the wall to check the pan and spout. ●The LED light may be damaged.
+LVHQVH 8.