Contents Safety and warning information 2 Cleaning and care 18 Installing your new appliance 8 Helpful hints and tips 20 Description of the appliance 14 Troubleshooting 21 Display controls 15 Disposal of the appliance 23 Using your appliance 17 This appliance is in accordance with the following EU guidelines: LVD 2014/35/EU and EMC 2014/30/EU and 2009/125/EC and EC.1060/2010 and 2002/96/EC.
If you are discarding the appliance, pull the plug out of the socket, cut the connection cable (as close to the appliance as you can) and remove the door to prevent children playing from suffering an electric shock or from closing themselves inside. If this appliance, featuring a magnetic door seals, is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make the spring lock unusable before you discard the old appliance.
appliance, unless they are of the type recommended by the manufacturer. WARNING — The refrigerant and insulation are flammable. When disposing of the appliance, do so only at an authorized waste disposal center. Do not expose to flame. Refrigerant The refrigerant isobutene (R600a) is contained within the refrigerant circuit of the appliance, a natural gas with a high level of environmental compatibility, which is nevertheless flammable.
of electric shock or fire. 6. You must not operate the appliance without the interior lighting lamp cover. 7. The fridge is only supplied with power supply of single phase alternating current of 220 ~ 240 V/50Hz. If fluctuation of voltage in the district of user is so large that the voltage exceeds the above scope, for safety sake, be sure to apply A.C. Automatic voltage regulator of more than 350W to the fridge.
for keeping food and/or beverages in normal households as explained in this instruction booklet The appliance is heavy. Care should be taken when moving it. Do not remove or touch items from the freezer compartment if your hands are damp/wet, as this could cause skin abrasions or frost/freezer burns. Never use the base, drawers, doors etc. to stand on or as supports. Frozen food must not be refrozen once it has been thawed out.
achieve sufficient ventilation, follow the instructions relevant to installation. Wherever possible the back of the product should not be close to a wall to avoid touching or catching warm parts (compressor, condenser) to prevent the risk of a fire, follow the instructions relevant to installation The appliance must not be locate close to radiators or cookers. Make sure that the mains plug is accessible after the installation of the appliance.
Installing your new appliance Before using the appliance for the first time, you should be informed of the following tips. Warning! For proper installation, this refrigerator must be placed on a level surface of hard material that is the same height as the rest of the flooring. This surface should be strong enough to support a fully loaded refrigerator. The rollers, which are not castors, should be only used for forward or backward movement.
the bottom feet may need to be adjusted. You can adjust them manually by hand or by using a suitable spanner. To allow the doors to self-close, tilt the top backwards by 10-15 mm. Whenever you want to move the appliance, remember to turn the feet back up, so that the appliance can roll freely. Reinstall the appliance when relocating. Then pass the refrigerator laterally. If you do not need to remove the appliance doors, go to ‘Installing the water lines’ on page 11.
3. Remove the 3 screws (B) fixed on the hinges with a Wrench (8mm) and 1 ground screws (C) attached to the hinge with Philips (+) screwdriver. Remove the upper left and right door hinges (D). Re-attaching the fridge doors To reattach the fridge doors after you have moved the appliance to its final location, assemble the parts in reverse order. 1.
5. Pull out the freezer door and lift it up in the direction of the arrow. 2. Take out the upper freezer drawer (A) by lifting it up from the rail system. Re-assembling assembling the freezer door To reattach the drawer after you moved the appliance to its final location, assembling the parts in reverse order. 3. Remove the lower freezer drawer (C) by lifting it up. 4. Remove the 4 screws attached to the supporting frame (D).
and Outlet of the water filter. 3. Insert the 2 clips in the proper position as the figure shown below, and confirm that each clip holds the water line firmly. ： Note The water lines must be fully inserted into the filter to prevent water leaking. The line length should be less than 5m. If the water line is too long(>5m), the ice and cold water content may be affected due to insufficient water pressure. Cut the water line as required length and avoid overbending the water lines.
if the lines are fully inserted where the connector leaked. If not, please install them again, and make sure that the lines are fully inserted. The initial dark discoloration of water is normal. The water lines must be connected with the potable water only. To operate properly, the ice maker requires a water pressure of 207~689 Kpa. Connect filter outlet line to the fridge The outlet line of the water filter should be connected with the inlet line of the refrigerator by a Two-Way Connector.
Description of the appliance ！ Note Due to unceasing modification of our products, your refrigerator may be slightly different from this instruction manual, but its functions and using methods remain the same. To get the best energy efficiency of this product, please place all shelves, drawers and baskets on their original position as the illustration above.
Display Controls Use your appliance according to the following control guidelines. The control panel on the top cover shows in the diagram below, it may be different depending on the model. When the appliance is powered on for the first time, the backlighting of the icons on the display panel starts working. If no buttons have been touched or the doors are closed, the backlighting will turn off after 60 seconds.
that can be correctly used in your refrigerator. After you change a new water filter, ensure to touch and hold the Ice On and Super Freeze buttons for 3 seconds to make the blink off. When you replace the water filter, some me water may leak from the filter and lines. Please let the water flow in a pan, and wipe up any leakage that may have occurred. “ ” “ ” “Freezer temperature control” You can touch the “Freezer” button to activate the mode to control the freezer temperature.
Alarm 10 minutes. When the door of fridge or freezer has To save energy, please avoid keeping the been opened for over 2 minutes, the door door open for a long time when using the alarm will sound. In case of door alarm, appliance. The door alarm can also be buzzer will sound 3 times every 1 minute cleared by closing the door. and will stop alarming automatically after Using your appliance This section tells you how to use most of the useful features.
to page 10 for disassembly instruction. Automatic Icemaker (optional) Automatic Icemaker can make ice automatic 。 Note: Don't push the dispenser lever forward without cup, it may cause the water leak from the dispenser. Do not immediately removing your cup or glass from the dispenser after dispensing water you need. You should wait for 2 or 3 seconds to prevent spills. Do not pull the lever out, it could damage or break the lever’s spring. Dispenser does not work when door is not closed.
Warning! The appliance must not be connected to the mains during cleaning. Danger of electrical shock! Before cleaning switch the appliance off and remove the plug from the mains socket. Exterior cleaning To maintain good appearance of your appliance, you should clean it regularly. Spray water onto the cleaning cloth instead of spraying directly on the surface of the appliance. This helps ensure an even distribution of moisture to the surface.
Caution! Only after the door seals are completely dry should the appliance be powered on Replacing the LED light Warning: The LED light must be replaced by a competent person. If the LED light is damaged, follow the steps below: 1. Unplug your appliance. 2. Remove light cover by rising up and pulling out the LED light. 3. Hold the LED light with one hand and pull it with the other hand while pressing the connector latch. 4. Replace LED light and snap it correctly in place and recover the light cover.
it to be rapidly and completely frozen and to make it possible to subsequently thaw only the quantity required. Once defrosted ， food will deteriorate rapidly and should not be re-frozen. Do not Wrap up the food in aluminum foil or polyethylene food wraps which are airtight, Do not allow fresh correctly by the food retailer ， unfrozen food to exceed the storage period indicated by the food manufacturer.
the The interior may need to be cleaned Odours from compartments Some food, containers or wrapping cause odours. The sounds below are quite normal: Compressor running noises. Air movement noise from the small fan motor in the freezer compartment or other compartments. Gurgling sound similar to water boiling. Popping noise during automatic defrosting. Clicking noise before the compressor starts. Noise from the appliance Clicking noise when you get the water.
Ice is not dispensing Did you wait for 12 hours after installation of the water supply line before making ice? If it is not sufficiently cool, it may take longer to make ice, such as when first installed. Is the water line connected and the water valve open? Did you manually stop the ice making function? Make sure you do not set the ice off mode.
equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by the inappropriate waste handling of this product. For more detailed information about the recycling of this product, please contact your local council your household waste disposal service, or the shop where you purchased the product.
