User's Manual

4. When pair is finished
(*2)
, the device will enter standby mode. The green
LED is flashing per 2 seconds.
(*1)
Only in standby mode, you can do pair procedure.
If you don’t sure which state is. You can plug-out and plug-in of car kit
plug again and wait the green LED flash once per 2 seconds. This is
standby mode now.
(*2)
¡If green LED turn off 3~6 seconds, you need restart pair procedure
again.
¡ Once pair is successful, you needn’t do pair procedure next time unless
you change another headset.
Note: The default PIN code is 1234
Connect with mobile phone
1. Plug audio cable into the headset ready mobile phone
(*3)
.
2. Maybe you need enable the auto answer function in your mobile
phone.
3. It will auto transfer to the headset directly when the call in.
Please adjust proper volume from your phone in order to avoid too much
sidetone or distortion.
4. It will auto enter the standby mode or low power mode if headset supports
for the power saving when ends call. It is like the hand-free in your
Bluetooth headset.
(*3)
¡Please refer to your wire headset plug header in order to select 3
or 4 nodes header of audio cable.
¡Some mobile phones are not headset ready, they may need an
adapter in order to transfer to 2.5 φ phone jack.
LED status
Standby mode Green LED flash once/2 sec
Pair mode Green LED flash once/0.5 sec
Talk mode Green LED flash once/1 sec