Ltd. Network Adapter User's Manual

2.3 Connecting to a Network the NIC
2-2
Installing the Network
Interface Card
Chapter 2
2.3 Connecting to a Network the NIC
Use an RJ45 connector (10/100BaseT) or BNC connector (10Base2) to
connect to an Ethernet.
1. Turn off the printer.
2. Connect the connector to the NIC.
3. After you make the connection, perform the procedure under 2.2
Powering Up the Printer.
Note
• Use a Category 5 cable when connecting with a 10/100BaseT.
• Be sure to use a cable with a ferrite core when making a 10/
100BaseT connection.
1
0/100BaseT:
P
lug an RJ45 connector into the
1
0/100BaseT port on the back of
t
he NIC. Attach the ferrite core so
t
hat it is near the connector. Next,
s
ecure the ferrite core so that it
c
annot move out of position using
t
he tie band.
10Base2:
Use a BNC T adapter to connect
to the BNC connector on the back
of the NIC.
Feritecore
Tie band