Operation Manual

Section 3 - Installation (ATSC EC702HP Transmitter)
Manual Rev. 0.0 - April 2016
3-40
 Locate the communication cable (with green connectors in its end) and connect it to the
digital exciters, taking into account the respective identification numbers and the picture
below.
Figure 3-52
Partial rear view of the
exciters
For additional information on the connection in the CONTROL I/O connector, refer to Annex A
(Connections CONTROL I/O - Exciter A and Exciter B).
C- Ethernet* Switch Cables (MOD SWT DES-1016D D-LINK)
 Make theconnection between the port 1 (or any otherport) of the switch module to CONTROL
PORT connector of the transmitter top panel.
 Make the connection between the port 9 of the switch module and the front port ethernet of
the digital exciter A.
 Make the connection between the port 10 of the switch module and the front port ethernet
of the digital exciter B.
 Make the connection between the port 3 of the switch module and the front port ethernet
of the GPRS unit.
 Connect the AC pigtail.
Figure 3-53
Ethernet Switch Connections
*Ethernet is a trademark of the Xerox Corporation.
GPRS UNIT
EXCITER A
PORT 9
EXCITER B
PORT 3
PORT 1
PORT 10
ETHERNET
SWITCH
CONNECTOR WITH IDENTIFICATION 1
CONNECTOR WITH IDENTIFICATION 2
CONNECTOR WITH IDENTIFICATION 3
CONNECTOR WITH IDENTIFICATION 4