User's Manual
Table Of Contents
- 1 System Overview
- 2 Features Summary
- 3 EXACT-V2 Rack
- 3.1 EXACT-V2 mechanics
- 3.2 Interface characteristics
- 3.3 Front Panel signalization (LEDs description)
- 3.4 Power requirements
- 3.5 Performances and technical characteristics
- 3.5.1 General characteristics
- 3.5.2 Control and data Ethernet interfaces
- 3.5.3 Serial control interfaces
- 3.5.4 ASI inputs / output and MPEG-TS processing
- 3.5.5 Digital modulation
- 3.5.6 Clock synchronization
- 3.5.7 RF and monitoring outputs
- 3.5.8 Digital precorrection
- 3.5.9 Power level measurement inputs and AGC
- 3.5.10 Dry contacts
- 3.6 Conformity with EC Directive
- 4 EXACT-V2 Installation
- 5 Operation
- 6 Maintenance & Troubleshooting
- Appendix A GPS Installation Recommendations
- Appendix B Example of GPS Antenna
USER
MANUAL
MPD-1611291-A
EXACT-V2 High End Rack Modulator / Exciter
3/10/2017
MPD-1611291-A
Page 15/94
2.1 Features Overview
Input Stream Management
ATSC 1.0 :
o 2x ASI/SMPTE 310M Inputs :
ASI: 188 or 204 byte format with RS decoding – TS/ASI (ETSI EN
102 773 - [D1] & [D2])
SMPTE 310M: 188 byte format
o 1x ASI Output (188 byte) – Stream output type: TS/ASI
o Redundancy management :
TS CleverSwitch: stream switching between Main and Secondary input
– See TS CleverSwitch control
o Bit rate adaptation & PCR re-stamping
o Null packet deletion
ATSC framing and channel encoding
o 8-VSB modulation core
o Virtual Channel Table Update
ATSC 3.0 : (Available from the S110 firmware version)
Digital Adaptive Non-Linear Precorrection circuits
o Flexible operating modes: STATIC (EDIT), SINGLE, SURVEY or
CONTINUOUS
o RF feedback signals sampled in real-time after Power Amplifier
Digital Linear Precorrection circuits
o Manual mode
o Adaptive mode : STATIC (EDIT) or SINGLE
o RF feedback signals sampled in real-time after RF filter
PAPR reduction system and protection clipping
RF output
o Frequency band: UHF and VHF band
o Bandwidth: 6MHz
o Main output (0dBm or optional +20dBm) and monitoring output (-20dB
relative to main output)