User's Manual
Table Of Contents
- 1 System Overview
- 2 Features Summary
- 3 EXACT-V2 Rack
- 3.1 EXACT-V2 mechanics
- 3.2 Interface characteristics
- 3.3 Front Panel signalization (LEDs description)
- 3.4 Power requirements
- 3.5 Performances and technical characteristics
- 3.5.1 General characteristics
- 3.5.2 Control and data Ethernet interfaces
- 3.5.3 Serial control interfaces
- 3.5.4 ASI inputs / output and MPEG-TS processing
- 3.5.5 Digital modulation
- 3.5.6 Clock synchronization
- 3.5.7 RF and monitoring outputs
- 3.5.8 Digital precorrection
- 3.5.9 Power level measurement inputs and AGC
- 3.5.10 Dry contacts
- 3.6 Conformity with EC Directive
- 4 EXACT-V2 Installation
- 5 Operation
- 6 Maintenance & Troubleshooting
- Appendix A GPS Installation Recommendations
- Appendix B Example of GPS Antenna
USER
MANUAL
MPD-1611291-A
EXACT-V2 High End Rack Modulator / Exciter
3/10/2017
MPD-1611291-A
Page 31/94
DAP mode activation
In the Settings Tab, the DAP mode can be enabled under Outputs > Precorrections:
Non-Linear DAP launch
The same protocol as the basic DAP applies (please refer to the previous chapter).
Note: Enabling or disabling the DAP causes a reset of the non-linear curves.
The user is then given the possibility to save the current curves, if needed.