User's Manual
Table Of Contents
- 1 System Overview
- 2 Features Summary
- 3 EXACT-V2 Rack
- 3.1 EXACT-V2 mechanics
- 3.2 Interface characteristics
- 3.3 Front Panel signalization (LEDs description)
- 3.4 Power requirements
- 3.5 Performances and technical characteristics
- 3.5.1 General characteristics
- 3.5.2 Control and data Ethernet interfaces
- 3.5.3 Serial control interfaces
- 3.5.4 ASI inputs / output and MPEG-TS processing
- 3.5.5 Digital modulation
- 3.5.6 Clock synchronization
- 3.5.7 RF and monitoring outputs
- 3.5.8 Digital precorrection
- 3.5.9 Power level measurement inputs and AGC
- 3.5.10 Dry contacts
- 3.6 Conformity with EC Directive
- 4 EXACT-V2 Installation
- 5 Operation
- 6 Maintenance & Troubleshooting
- Appendix A GPS Installation Recommendations
- Appendix B Example of GPS Antenna
USER
MANUAL
MPD-1611291-A
EXACT-V2 High End Rack Modulator / Exciter
3/10/2017
MPD-1611291-A
Page 56/94
3.5.5 Digital modulation
Characteristics Typical Value Comment
ATSC Modulation
ATSC Mode: 8VSB According to ATSC A/53
Channel Bandwidth: 6 MHz
Characteristics Typical Value Comment
Modulation Performances
In Band SNR (Eq. OFF):
≥ 30 dB
EVM (Eq. OFF):
≤ 2.0%
MER (Eq. OFF):
≥ 30 dB
MER (Eq. ON):
≥ 45 dB
Shoulder and Out of Band
Rejection:
≥ 63 dB
≥ 57 dB / ≥ 63 dB with precor
≥ 63 dB typical
From pilot level
EXACT-V2
EXACT-V2-20dB at +20 dBm
EXACT-V2-20dB at +17 dBm
Spurious: ≤ -50 dBc Relative t
o the total power of the
signal at nominal output power
Amplitude Ripple:
≤ 0.2 dB typical
Group Delay Ripple:
≤ 20 ns typical
Pilot Carrier Phase Noise:
≤ -104 dBc/Hz @ 20 kHz up to
700 MHz
PAPR
Configuration Range:
Pre-clipping Optimization:
Protection Clipping:
8 to 20 dB (0.1 dB step)
0 to 255
8 to 20 dB (0.1 dB step)
Characteristics Typical Value Comment
Miscellaneous
Automatic Mute:
Configurable on stream errors
Configurable on clock errors
Configurable Timeout (LORS)
RF Maintain: Configurable on stream errors
Spectrum Reverse: Configurable
Test Modes: Single sine tone / +6 dB Sinus
PRBS