User Guide

(6) Vertical Size
Adjust this control to the preferred height.
(7) Vertical Position
Adjust this to place the display at the centre of the screen.
(8) Signal Cable
Connect the end of the cable to your computer.
(9) Power Cord In-let Connector
Insert proper power cord here.
BEFORE CONNECTING THE MONITOR TO YOUR
COMPUTER, MAKE SURE THE POWER TO THE MONITOR
AND COMPUTER ARE TURNED OFF.
1. Connect the signal cable to your computer’s video output connector. The comec-
tor is compatible with IBM PS/2 series computers and VGA standard graphics
cards for IBM PC, PC/XT, PC/AT, and compatibles. When you are using the
monitor with Apple Macintosh II computer, please obtain an optional converter for
connection from your dealer. Hitachi’s part number for convertec
2. Connect power cord to the monitor then to wall power outlet.
USE PROPERLY APPROVED POWER CORD...HO5VVHZF.
Se-l
3. Power on the monitor then power on your computer. When you switch OFF,
reverse the sequence.
4. Adjust front located user controls to obtain right picture size, location, and
brightness. Display location on the screen and the size may change when you switch
from one application software to another one.
5. Adjust Tilt& Swivel to suit your eye level.
.
DO NOT use the monitor with a bright background light, direct sunshine, or bright
light into the screen area. These may increase eye fatigue.
14MVX User Manual 5