Operation Manual

- 17 -
Selecting Search
To start the search process, press 
 but-
ton for forward search or 
 button for back-
ward search. If a signal is found or reaches
to end of the band after searching, press

 or   buttons to continue search pro-
cess. To stop the search process when you
want, press   or   buttons again.
Selecting Fine Tuning
You can use the Fine Tuning process for
fine adjustment (after coarse adjustment), if
you are not happy about the image on the
screen.
Use 
 or   button on Fine Tuning item,
until getting the best image on the screen.
Normally the Fine Tuning cursor is placed
next to the left side on the slider and this is
indicated with one arrow.
Setting VCR ( Video Cassette Recorder )
Mode
 This item can be seen in TV, AV-1, AV-2, AV-3,
S-VIDEO modes.
 If you want to watch a VCR source from one
of these modes, then it will be better to set
VCR mode on. For this, while the cursor is
on this item press the 
 or   buttons to
set it On.
 If you want to watch a DVD , then you must
set this item off; because DVD is not a
source like a VCR and to see the picture
better, you must set the VCR mode Off.
To Store Settings
 Press OK button on the remote control to
store the settings directly.
or,
 Press 
,   or OK button on Store op-
tion to store Install menu settings.
Programme Menu
 To enter Programme menu directly, press
the "
" button in TV mode, or
 Press "M" button, now you are in main
menu. In the main menu, select Program.
using   or   button. Then enter the
Programme menu, press 
 /   or OK
button.
0HQX
Moving cursor to four direction you can reach
20 programmes in the same page. By
scrolling the pages up or down by pressing
the navigation buttons you can select all the
programmes in TV mode (except the AV
mode).
By cursor action, programme selection is
done automatically. It is also possible to se-
lect programme by using digit or double-
digit button. In this way programme selec-
tion is also automatic. The TV Status is
changed by the programme selection too.
When using double-digit button in order to
select a programme, the Programme Num-
ber in TV Status OSD is displayed in "P --"
form, and by pressing digit buttons they are
displayed in it.
Programme Number is between 00 and 99.
Programme Name has a name string with 4
characters. After autostore process the Pro-
gramme Names are set to:
 Channel search "C-01" or "S-01" (band
and channel number) or name of the tuned
channel if defined.
3URJUDP3
1DPH
'HOHWH
,QVHUW
$XWRVWRUH
ENG-2200-1547UK-22 INCH TFT IB.p65 03.03.2004, 17:5917