Use and Care Instructions For your new HITACHI Refrigerator-Freezer MODEL R-26SVH R-26SVND CONTENTS PAGE SAFETY SUGGESTIONS .................... 2 !"#$%& SAFETY PRECAUTIONS .................... 4 !"# PARTS IDENTIFICATION .................... 5 ! INSTALLATION .................................... 6 !"# HOW TO INSTALL AND ....................... 7 REMOVE PARTS !"#$%& TEMPERATURE CONTROL ................ 8 ! FOOD STORAGE............................... 10 ! CLEANING ............
SAFETY SUGGESTIONS Suggestions below are very important for safety use of the refrigerator. !"#$%& !"#$%&'()*+,!"#$ • Plug in refrigerator to the proper wall outlet, properly fused according to its electrical ratings. An individual appliance circuit from fuse box is preferable. • !"!#$%&'(!)=E !"#$%&'()*+F !"#$ !"#$ • Handle the power cord carefully. A damaged power cord will cause troubles such as fire or a short circuit.
• Drugs, chemicals, research and experimental substances should not be stored in the refrigerator Substances that require precise conditions for storage cannot be stored in a domestic refrigerator • !"#$%"&'()*+",-./012 !"#$%&'()*+,-./01234 • Do not remodel this refrigerator. Also other than repair technicians, do not disassemble or repair it, which can result in fire, electric shock, or injury. • !"#$%&'()*+,-)*.
SAFETY PRECAUTIONS !"# Please strictly comply with the following safety precautions / !"#$%&'()* WARNING Air conditioning Solution (since it is flammable gas, you are required to be careful in the following matters) =E !"#$%&'()*+,-./F It is prohibited to use sharp articles, such as, sharp iron to abrade or scrape on the refrigerator body.
PARTS IDENTIFICATION ! Your model may differ in some features from the picture model. !"#$%&'()*+ • DOOR POCKET • For storage of bottles, canned foods, etc. • • !"#$%&'() SHELVES DEFROSTING MID MIN MID MAX MIN MAX • FRESH ROOM • !" For storage of fresh meat, fish, prawn and process foodstuff. !"#$%&$'()*+, • VEGETABLE COMPARTMENT • For storage of fresh vegetables and fruit.
INSTALLATION / 10 cm at the top =NM= • Install refrigerator in convenient location away from extreme heat and cold. This refrigerator is designed as a free-standing unit, so don’t set it built-in. Provide at least 10 cm (4 inches) at the top and rear, at least 5 cm (2 inches) at sides for proper air circulation. • Level refrigerator so it rests solidly on the floor without rocking. The leveling legs are located at front corners. Turn clockwise to raise the corner, counterclockwise to lower it.
HOW TO INSTALL AND REMOVE PARTS !"#$%& DOOR POCKET/EGG POCKET L Remove the door pocket as shown. !"#$%& TAP TAP TAP TAP MID MIN MID MAX MIN MAX FRESH ROOM !" • Remove the “FRESH ROOM” as shown below. !"#$%&'()%*)+, ! Do not store more than 4.2kg in the “FRESH ROOM” or it may be broken. !"#$%&'(=QKO !"#$%&'%() !"#$ FREEZER COMPARTMENT 1 To remove slide case, lift it up as shown. !"#$%&' Upper Freezer case ! Do not store more than 5.
TEMPERATURE CONTROL / ! In normal situation, please use the “MID” position for both refrigerator and freez. !"#I !"#$%"&'()*+,-. • When you want to change the temperature, please turn the dial to the position you prefer. • !"#$%&'()*+,-. !/012 Refrigerator Temp. Control MID MIN MAX MIN Approx. 2°C higher than “MID” !"#$=O°` MID Approx. 3~6°C I=PúS°` MAX Approx. 2°C lower than “MID” !"#=O°` MIN Approx. 2°C higher than “MID” !"#$=O°` MID Approx.
REFRIGERATOR / Lamp Cover Inner Light (within the lamp cover) =E !"F Plain Salver (Level 1, 2) =E NIO F The plain salver (middle tray) can be adjust to fit the food height or usege =E !F= !I !"#$%&'( MID MIN MID MAX MIN MAX • Lift the inner part of salver up a little and pull it to the front. Then, it can be removable. • !"#$%&'()*+,'-./01 • Please adjust the tray to the level that you prefer and push it until it reaches the deepest point. • !"#$%&'()*+,-&.
FOOD STORAGE ! INITIAL OPERATION • Clean refrigerator and parts to remove dust incurred in shipping and packing. See “CLEANING” • Place all shelves and containers in their proper positions which have been removed for transportation. See “HOW TO INSTALL AND REMOVE PARTS”. • Store food after the temperature in the refrigerator gets sufficiently low. It takes a few hours after starting the refrigerator to reach the proper temperature. !" • !"#$%&'()*+,-./0 !" #$%&'() • !"#$%&'()*+",-.
CLEANING CLEANING • Removable parts may be rinsed with water. • For cleaning the refrigerator, wipe the refrigerator with a damp cloth or sponge. Mild soap may be used. • If soap is used, rinse the refrigerator thoroughly with water and wipe it dry. • Never use a hard brush, harsh, abrasive cleansers, heavy-duty cleansers or solvents, such as paint thinner, benzene, petroleum, soap-power, hot water, acid, etc. on any surface.
TROUBLESHOOTING !"#$%&'() Before you call for service, check the following items. • !"#$%&'()*+,-./ 1. The refrigerator does not run. • Check the power supply at the wall outlet. • Make sure the power supply cord is plugged firmly. • Check the fuse box for blown fuse or tripped circuit breaker. NK !"#$ • !"#$%& • !"#$ %& 2. Food temperature is too warm. • Check the temperature control dial setting. See “TEMPERATURE CONTROL”. Check spaces among the foodstuffs.
WHEN ELECTRICITY FAILS / VACATIONING !=L= ! THESE ARE NOT DEFECTIVE • When the refrigerating unit stops, the flow of the refrigerant may make a sound. This is the sound of the refrigerant flowing in the refrigerating unit. • The mullion bar between the vegetable compartment and the freezer compartment is warmed by hot gas pipe. It will sometimes feel warm. But do not worry about stored food. • Electronic parts which has moving contact point are installed this refrigerator.
– MEMO – 14 RPK3750202
– MEMO – 15 RPK3750202
WARNING • Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. • Do not use electrical appliances inside the food storage compartments of the appliance unless they are of the type recommended by the manufacturer. • Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. • Do not damage the refrigerant circuit.