Owner's manual

USING THE GENIUS REMOTE TO LEARN ADDITIONAL
FUNCTIONS (31GX31B ONLY)
TABLE 4. Cable Box Precoded remote controls for Hitachi GJ III and GJ II Remote
CLU-692GR and CLU-681GJ
Press SELECT and this
CATV brand button
General Instrument 0 / 1 / 2 / 3 / 8
Hamlin 4
Jerrold 0 / 1 / 2 / 3 / 8
Pioneer 7
Regal 4
Scientific Atlantic 6
Viewstar 9
Zenith 5
USING THE GENIUS REMOTE TO LEARN ADDITIONAL
FUNCTIONS (31GX31B ONLY)
• The Genius Remote is equipped with a learning function which allows it to learn
additional infrared control codes. This remote will not only control the television, a VCR,
and a cable box, but also other electronic equipment which uses an infrared remote
transmitter, by learning the transmitter's codes.
• Only infrared remote control codes can be stored in memory.
Before starting the memory operation
• Since the infrared signals sent from the remote transmitter may be reflected by a wall,
door, etc., even if the transmitter is not pointed directly at the device, it may operate.
When storing the remote control codes of another device, turn OFF the power of the
device (VCR, Cable Converter, etc.)
If you do not do this, the device may work unexpectedly. The power could be turned
ON, an important tape could be erased, the volume could increase too much, etc..
Click to see CLU-851GR in the USER position
 LEARNABLE BUTTONS
These buttons can "learn" the codes of other remote control transmitters when the
MULTI-PAGE select switch is set to the "USER" mode.
 MULTI-PAGE keys (A through L): No codes have been factory stored to these keys.
 Learning buttons other than MULTI-PAGE buttons: the codes for the TV have been
stored in memory. However, the remote control codes of other equipment (cable
converter, audio equipment, etc.) can be stored using the learning function as shown on
page 37 and later.