User Guide

33
ENGLISH
OPERATING INSTRUCTIONS (continued)
SETUP MENU (RGB mode: RGB1 (DVI-PC), RGB2 (RGB)) (continued)
Selected characters
 
Setup hint
Vertical Filter
Off On
Turn On when concerned about screen flicker.
Frequency Mode
Greyed out This function is not available.
RGB1
DVI-PC DVI-STB
This should correspond to the signal mode of the signal from the equipment
that is connected to RGB1 DVI terminal.
RGB2 (1st step)
RGB Component
This should correspond to the signal mode of the signal from the equipment
that is connected to RGB2 D-sub terminal.
RGB2 (2nd step)
A
uto HDTV SDTV/DVD
This step should be set only when [Component] is selected on the 1st step.
This should correspond to the signal mode of the signal from the equipment
that is connected to RGB2 D-sub terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognised.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
* Depending on the type of signal displayed, displays may not be optimized through automatic adjustment. Adjust manually to optimize them.