Manual

USING THE REMOTE TO CONTROL VCR FUNCTIONS

Operating the preceded function for your VCR.

This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your

VCR. (Refer to page 34).

!. Turn ON yourVCR.

2. Aim the remote control at the front of your VCR.

3. Press the VCR button to switch to the VCR pre-coded mode.

4. Hotd down the VCR button on the remote, enter the two digit preset code that matches your VCR as shown in page 34. The remote

will turn off your VCR when the correct two digit preset code is entered. When this occurs, the remote control is programmed for

your VCR. If the VCR does not turn off after five seconds, try a different two digit preset code.

5. The remote wilI now control your VCR,

VCR Button

This button allows the remote to control

VCR by setting it to VCR mode_

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

PRECODED VCR Buttons

buttons transmit the chosen precoded

VCR codes. For some VCRs, you must press

the RECORD button twice to record a

program

NOTES:

I, If your VCR cannot be operated after performing the above procedures, your VCR's code has not been precoded into the remote.

2 In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult your VCR operating

guide.

3. The remote control will remember the codes you have programmed until the batteries are removed from the remote control After

replacing the batteries repeat the entire programming procedure as stated above.

4. The INPUT button will act as your VCR '100' button if required.

NOTE: Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.