Manual

USING THE REMOTE TO CONTROL
CABLE BOX/SATELLITE FUNCTIONS
iii
Operating the precoded function for your cable/satellite box.
This remote is designed to operate different types of cable boxes and satellite systems. You must first program the remote to match the
remote system in your cable/satetfite box. (Refer to page 34).
1. Turn ON your cable/satellite box.
2_ Aim the remote control at the front of your cable/satellite box
3• Press the CABLE button on the remote to switch to cable/satellite mode.
4. Hold down the CABLE button on the remote, enter the two digit preset code that matched your cable/satellite box as shown on page
34. The remote wil! turn off your cable/satellite box when the correct two digit preset code is entered. When this occurs, the remote
control is programmed for your cable/satellite box. if the cable/satellite box does not turn off after five seconds, try another two digit
preset code.
5. The remote wil! now control your cable/satellite box.
CABLE Button
This button allows the remote to control vour
cable/satellite box by setting it to cable
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
PRECODED CABLE/SATELLITE Box Buttons
buttor_s transmit the chosen precoded
CABLE/SATEI.LtTE codes.
NOTES:
1. If your cable/satellite box cannot be operated after performing the above procedures, your cable/satellite box code has not been
precoded into the remote.
2. In the unlikely event that your cable/satellite box cannot be operated after performing the above procedures, please consult your
cable/satellite box operating guide.
3. The remote control will remember the codes you have programmed until the batteries are removed from the remote control After
replacing the batteries repeat the entire programming procedure as stated above.
33